[RFC PATCHv3 1/6] arm: Initial TI-Nspire support

[Daniel Tang]

On 12/05/2013, at 7:06 PM, Russell King - ARM Linux <linux at arm.linux.org.uk> wrote:

> On Sun, May 12, 2013 at 02:22:56PM +1000, Daniel Tang wrote:
>> 
>> +	.bpp		= 8,
>> +	.grayscale	= 1
>> +};
> 
> Still no capabilities in the above - how does the CLCD controller know
> which of BGR or RGB output and which format these panels support?
> 
> Each entry needs a .caps = CLCD_CAP_xxx | CLCD_CAP_xxx listing the
> formats supported there.
> 
> Unless panels and the board have a .caps entry, the caps system won't
> be used.

Fair enough.

> 
>> +static struct clcd_board nspire_clcd_data = {
>> +       .name           = "LCD",
>> +       .caps           = CLCD_CAP_ALL,
> 
> Your board has logic to support the RGB444/BGR444 mode?  If not, setting
> CLCD_CAP_ALL is incorrect.

I believe the grayscale panel supports the xGx444 modes - unsure about the colour one. Since I'm using the same struct clcd_board for both panels, I thought I'd just set caps to work with both to simplify.

Should I set board caps to panel caps on setup?

Cheers,