[RFC PATCH 0/3] ARM: omap3: add Seagate Wireless Plus board

[Tony Lindgren]

* Jason Cooper <jason at lakedaemon.net> [130508 17:41]:
> On Wed, May 08, 2013 at 12:45:04PM -0700, Tony Lindgren wrote:
> > * Jason Cooper <jason at lakedaemon.net> [130508 12:29]:
> > > 
> > > Tony has been helping me out offline with this, and he suggested trying the
> > > gpmc against Linus' ToT.  Which locks up before it even has a chance to get
> > > going.  So this series is against v3.9.
> > 
> > You may have better luck with today's mainline treeand the following fix:
> > 
> > http://lkml.org/lkml/2013/5/8/374#
> 
> Ok, I'm attempting to do that, but got this for 'make dtbs':
> 
> ERROR (phandle_references): Reference to non-existent node or label "usb2_phy"
> 
> ERROR: Input tree has errors, aborting (use -f to force output)
> make[1]: *** [arch/arm/boot/dts/omap3-wireless_plus.dtb] Error 2
> make[1]: *** Waiting for unfinished jobs....
> make: *** [dtbs] Error 2
> 
> which was created by:
> 
>   ad871c10 ARM: dts: OMAP: Add usb_otg and glue data to OMAP3+ boards
> 
> It assumes the board has twl4030 (and then includes it).  Bootlogs from
> the vendor provided kernel don't show a single message from twl4030, so
> I've omitted it.
> 
> Assuming I did the correct thing by omitting the twl4030, I think the
> correct answer is to declare the phy in the dts files, like so:

Thanks, that is correct. We should not assume any PMIC with a processor
as it can also be a custom chip. For example, Nokia n8x0 is using their
retu + tahvo chips instead of tps chips.

I'll apply your patch into omap-for-v3.10/fixes.

Regards,

Tony