[PATCH 28/63] ARM: ux500: Stop passing UART's platform data for Device Tree boots

[Lee Jones]

On Fri, 03 May 2013, Linus Walleij wrote:

> On Fri, May 3, 2013 at 4:32 PM, Lee Jones <lee.jones at linaro.org> wrote:
> 
> > It was required to pass DMA channel configuration information to the
> > UART driver before the new DMA API was in place. Now that it is, and
> > is fully compatible with Device Tree we can stop doing that.
> >
> > Reviewed-by: Linus Walleij <linus.walleij at linaro.org>
> > Signed-off-by: Lee Jones <lee.jones at linaro.org>
> 
> I can't apply this as it is clearly dependent on a patch to
> drivers/tty/serial/amba-pl011.c that is not yet upstream.

Right, I'll move this patch to the end of the patch-set.

-- 
Lee Jones
Linaro ST-Ericsson Landing Team Lead
Linaro.org │ Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog