[PATCH 19/63] dmaengine: ste_dma40: Separate Logical Global Interrupt Mask (GIM) unmasking

[Linus Walleij]

On Fri, May 3, 2013 at 4:32 PM, Lee Jones <lee.jones at linaro.org> wrote:

> During the initial setup of a logical channel, it is necessary to unmask
> the GIM in order to receive generated terminal count and error interrupts.
> We're separating out this required code so it will be possible to move
> the remaining code in d40_phy_cfg(), which is mostly runtime configuration
> into the runtime_config() routine.
>
> Cc: Vinod Koul <vinod.koul at intel.com>
> Cc: Dan Williams <djbw at fb.com>
> Cc: Per Forlin <per.forlin at stericsson.com>
> Cc: Rabin Vincent <rabin at rab.in>
> Acked-by: Arnd Bergmann <arnd at arndb.de>
> Signed-off-by: Lee Jones <lee.jones at linaro.org>

These review comments are only partially accounted for:
http://marc.info/?l=linux-kernel&m=136688761708399&w=2

Please supply a short changelog in the next submission
so I know what was changed and why some things were not
changed and if you split out other changes to other patches
etc etc.

Yours,
Linus Walleij