[PATCH] ARM: ux500: Remove DMA address look-up table

[Lee Jones]

On Fri, 03 May 2013, Linus Walleij wrote:

> On Thu, May 2, 2013 at 10:51 AM, Lee Jones <lee.jones at linaro.org> wrote:
> 
> > DMA addresses are now passed as part of the dmaengine API by invoking
> > dmaengine_slave_config(). So there's no requirement for the DMA40
> > driver to look them up in a table provided by platform data. This
> > method does not fit in well using Device Tree either.
> >
> > Signed-off-by: Lee Jones <lee.jones at linaro.org>
> 
> This goes on top of some other changes right?
> 
> Right now the DMA series is confusing me a bit, there is
> these 6 patches:
> http://marc.info/?l=linux-arm-kernel&m=136698179306642&w=2
> 
> Then these 5 patches:
> http://marc.info/?l=linux-arm-kernel&m=136740201416293&w=2
> 
> And then this single patch.

Right. I can prepare one big branch if you like.

> Where shall I start, i.e. which patches go first?
> 
> Can they all be combined into one big series?

-- 
Lee Jones
Linaro ST-Ericsson Landing Team Lead
Linaro.org │ Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog