[PATCH 1/5 v2] dmaengine: ste_dma40: Allow memcpy channels to be configured from DT

[Linus Walleij]

On Wed, May 1, 2013 at 11:52 AM, Lee Jones <lee.jones at linaro.org> wrote:

> At this moment in time the memcpy channels which can be used by the D40
> are fixed, as each supported platform in Mainline uses the same ones.
> However, platforms do exist which don't follow this convention, so
> these will need to be tailored. Fortunately, these platforms will be DT
> only, so this change has very little impact on platform data.
>
> Cc: Vinod Koul <vinod.koul at intel.com>
> Cc: Dan Williams <djbw at fb.com>
> Cc: Per Forlin <per.forlin at stericsson.com>
> Cc: Rabin Vincent <rabin at rab.in>
> Signed-off-by: Lee Jones <lee.jones at linaro.org>

Real nice!

But can you split this in two patches: one that changes
drivers/dma/ste_dma40* and one sequel patch that changes
Documentation/* and arch/arm/boot/dts/* so I can merge them
out-of-order?

I am trying this development cycle to split changes to the
device trees and bindings off from the rest of the patches
becaused it caused me a mess last cycle.

Yours,
Linus Walleij