[PATCH] iio: mxs-lradc: Do hardware initialization earlier

[Marek Vasut]

Dear Alexandre Belloni,

> On 28/03/2013 12:22, Marek Vasut wrote:
> > Dear Alexandre Belloni,
> > 
> >> We need to initialize hardware before registering the touchscreen. Else,
> >> we end up setting registers in mxs_lradc_ts_open(), getting called just
> >> after registering the touchscreen with input_register_device() and by
> >> the end of mxs_lradc_probe(), we reset the LRADC block hence losing the
> >> correct configuration.
> >> 
> >> Cc: Fabio Estevam <fabio.estevam at freescale.com>
> >> Cc: Jonathan Cameron <jic23 at kernel.org>
> >> Cc: Marek Vasut <marex at denx.de>
> >> ---
> >> 
> >>  drivers/staging/iio/adc/mxs-lradc.c |    6 +++---
> >>  1 file changed, 3 insertions(+), 3 deletions(-)
> >> 
> >> diff --git a/drivers/staging/iio/adc/mxs-lradc.c
> >> b/drivers/staging/iio/adc/mxs-lradc.c index 55a459b..e927e3f 100644
> >> --- a/drivers/staging/iio/adc/mxs-lradc.c
> >> +++ b/drivers/staging/iio/adc/mxs-lradc.c
> >> @@ -933,6 +933,9 @@ static int mxs_lradc_probe(struct platform_device
> >> *pdev)
> >> 
> >>  	INIT_WORK(&lradc->ts_work, mxs_lradc_ts_work);
> >> 
> >> +	/* Configure the hardware. */
> >> +	mxs_lradc_hw_init(lradc);
> >> +
> >> 
> >>  	/* Check if touchscreen is enabled in DT. */
> >>  	ret = of_property_read_u32(node, "fsl,lradc-touchscreen-wires",
> > 
> > Isn't this too early? At least lradc->use_touchscreen is configured only
> > after you call mxs_lradc_hw_init() in this case, while
> > mxs_lradc_hw_init() uses it's value.
> > 
> > I think mxs_lradc_hw_init() shall be called just before
> > mxs_lradc_ts_register().
> 
> That's right, this would break 5 wires touchscreens. I'll fix that.

Thanks!

Best regards,
Marek Vasut