[PATCH v2 5/5] ARM: imx: Remove cpufreq driver
Markus Pargmann
mpa at pengutronix.de
Wed Mar 27 11:14:54 EDT 2013
On Wed, Mar 27, 2013 at 10:05:31PM +0800, Shawn Guo wrote:
> On Wed, Mar 27, 2013 at 02:01:34PM +0100, Markus Pargmann wrote:
> > The old cpufreq driver is not necessary anymore with DT and
> > cpufreq-cpu0.
> >
> > Signed-off-by: Markus Pargmann <mpa at pengutronix.de>
> > ---
> > arch/arm/Kconfig | 7 --
> > arch/arm/mach-imx/Makefile | 1 -
> > arch/arm/mach-imx/cpu_op-mx51.c | 31 -----
> > arch/arm/mach-imx/cpu_op-mx51.h | 14 ---
> > arch/arm/mach-imx/cpufreq.c | 206 ----------------------------------
> > arch/arm/mach-imx/mach-cpuimx51sd.c | 5 -
> > arch/arm/mach-imx/mach-mx51_babbage.c | 4 -
> > 7 files changed, 268 deletions(-)
> > delete mode 100644 arch/arm/mach-imx/cpu_op-mx51.c
>
> Target cpu_op-mx51.o should be removed from Makefile then.
>
> I fixed it up and applied the series expect the first patch. I expect
> you will send follow-up patches to add imx51 operating-points into
> device tree though.
Thanks.
I just prepared a patch for mx51 babbage board. cpuimx51sd does not seem
to have a DTS file yet. In general I think the operating points have to
be in the board specific DTS files because the frequencies of imx51
devices are different.
Regards,
Markus
--
Pengutronix e.K. | |
Industrial Linux Solutions | http://www.pengutronix.de/ |
Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 |
Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 |
More information about the linux-arm-kernel
mailing list