[PATCH 5/5] ARM: hackberry: dt: Add Ethernet controller to the Hackberry device tree
Maxime Ripard
maxime.ripard at free-electrons.com
Sat Mar 23 18:30:14 EDT 2013
The Hackberry has a PHY that needs to be powered up through a GPIO, so
we need to use a fixed regulator here.
Signed-off-by: Maxime Ripard <maxime.ripard at free-electrons.com>
---
arch/arm/boot/dts/sun4i-a10-hackberry.dts | 32 +++++++++++++++++++++++++++++
1 file changed, 32 insertions(+)
diff --git a/arch/arm/boot/dts/sun4i-a10-hackberry.dts b/arch/arm/boot/dts/sun4i-a10-hackberry.dts
index f84549a..072d51f 100644
--- a/arch/arm/boot/dts/sun4i-a10-hackberry.dts
+++ b/arch/arm/boot/dts/sun4i-a10-hackberry.dts
@@ -23,8 +23,40 @@
};
soc {
+ pio: pinctrl at 01c20800 {
+ pinctrl-names = "default";
+ pinctrl-0 = <&hackberry_hogs>;
+
+ hackberry_hogs: hogs at 0 {
+ allwinner,pins = "PH19";
+ allwinner,function = "gpio_out";
+ allwinner,drive = <0>;
+ allwinner,pull = <0>;
+ };
+ };
+
uart0: uart at 01c28000 {
status = "okay";
};
+
+ emac: ethernet at 01c0b000 {
+ pinctrl-names = "default";
+ pinctrl-0 = <&emac_pins_a>;
+ phy-supply = <®_emac_3v3>;
+ status = "okay";
+ };
+ };
+
+ regulators {
+ compatible = "simple-bus";
+
+ reg_emac_3v3: emac-3v3 {
+ compatible = "regulator-fixed";
+ regulator-name = "emac-3v3";
+ regulator-min-microvolt = <3300000>;
+ regulator-max-microvolt = <3300000>;
+ enable-active-high;
+ gpio = <&pio 7 19 0>;
+ };
};
};
--
1.7.10.4
More information about the linux-arm-kernel
mailing list