[PATCHv2 2/7] arm: vt8500: Increase available GPIOs on arch-vt8500
Russell King - ARM Linux
linux at arm.linux.org.uk
Sat Mar 23 06:44:02 EDT 2013
On Sat, Mar 23, 2013 at 06:13:48PM +1300, Tony Prisk wrote:
> With the inclusion of the pin control driver, more GPIO pins have been
> identified on the arch-vt8500 SoCs requiring an increase in the available
> GPIOs.
>
> Signed-off-by: Tony Prisk <linux at prisktech.co.nz>
> ---
> arch/arm/Kconfig | 3 ++-
> 1 file changed, 2 insertions(+), 1 deletion(-)
>
> diff --git a/arch/arm/Kconfig b/arch/arm/Kconfig
> index 5b71469..c5dd0c2 100644
> --- a/arch/arm/Kconfig
> +++ b/arch/arm/Kconfig
> @@ -1661,9 +1661,10 @@ config ARCH_NR_GPIO
> int
> default 1024 if ARCH_SHMOBILE || ARCH_TEGRA
> default 355 if ARCH_U8500
> + default 352 if ARCH_VT8500
> default 264 if MACH_H4700
> default 512 if SOC_OMAP5
> - default 288 if ARCH_VT8500 || ARCH_SUNXI
> + default 288 if ARCH_SUNXI
Note that the ordering of this has been fixed in -rc, so the above will
cause a merge conflict. You may wish to consider basing your patch set
on a later kernel version.
More information about the linux-arm-kernel
mailing list