[PATCH 2/3] ARM: sched_clock: support 64-bit counters

[Rob Herring]

On 03/21/2013 09:02 AM, Christopher Covington wrote:
> Hi Rob,
> 
> On 03/11/2013 10:26 PM, Rob Herring wrote:
>> From: Rob Herring <rob.herring at calxeda.com>
>>
>> With architected timers, we now have 64-bit counters which can be used
>> directly for sched_clock. However, the ARM sched_clock code currently just
>> uses the lower 32-bits and handles wrapping in software. Add support for
>> using the full 64-bit counter values. If multiple counters are registered,
>> a 64-bit counter is preferred.
> 
> To be more precise, architected timers are anywhere between 56 and 64 bits
> wide, zero-extended to 64-bits. See section B8.1.1 of the ARM ARM rev C.b. I
> don't know if the code really needs to change until someone has a need to
> distinguish more finely between timers, but if you're using access size as an
> approximation for counter width, I feel like it at least deserves a mention in
> the comments.

Is there a defined way to determine the number of active bits?
setup_sched_clock could be generalized to take any sizes >32 - 64 bits,
but then we need some threshold as to when we need to worry about
wrapping or not.

Rob