[PATCH v4 18/21] ARM: OMAP: zoom: Adapt to ehci-omap changes
Roger Quadros
rogerq at ti.com
Wed Mar 20 11:44:57 EDT 2013
Use usbhs_init_phys() to register the PHY's RESET regulator
and the NOP PHY device.
Signed-off-by: Roger Quadros <rogerq at ti.com>
---
arch/arm/mach-omap2/board-zoom.c | 16 ++++++++++------
1 files changed, 10 insertions(+), 6 deletions(-)
diff --git a/arch/arm/mach-omap2/board-zoom.c b/arch/arm/mach-omap2/board-zoom.c
index 5e4d4c9..1a3dd86 100644
--- a/arch/arm/mach-omap2/board-zoom.c
+++ b/arch/arm/mach-omap2/board-zoom.c
@@ -92,14 +92,16 @@ static struct mtd_partition zoom_nand_partitions[] = {
},
};
+static struct usbhs_phy_data phy_data[] __initdata = {
+ {
+ .port = 2,
+ .reset_gpio = ZOOM3_EHCI_RESET_GPIO,
+ .vcc_gpio = -EINVAL,
+ },
+};
+
static struct usbhs_omap_platform_data usbhs_bdata __initdata = {
- .port_mode[0] = OMAP_USBHS_PORT_MODE_UNUSED,
.port_mode[1] = OMAP_EHCI_PORT_MODE_PHY,
- .port_mode[2] = OMAP_USBHS_PORT_MODE_UNUSED,
- .phy_reset = true,
- .reset_gpio_port[0] = -EINVAL,
- .reset_gpio_port[1] = ZOOM3_EHCI_RESET_GPIO,
- .reset_gpio_port[2] = -EINVAL,
};
static void __init omap_zoom_init(void)
@@ -109,6 +111,8 @@ static void __init omap_zoom_init(void)
} else if (machine_is_omap_zoom3()) {
omap3_mux_init(board_mux, OMAP_PACKAGE_CBP);
omap_mux_init_gpio(ZOOM3_EHCI_RESET_GPIO, OMAP_PIN_OUTPUT);
+
+ usbhs_init_phys(phy_data, ARRAY_SIZE(phy_data));
usbhs_init(&usbhs_bdata);
}
--
1.7.4.1
More information about the linux-arm-kernel
mailing list