[PATCH v4 09/21] ARM: OMAP3: cm-t35: Adapt to ehci-omap changes

[Roger Quadros]

Use usbhs_init_phys() to register the PHY's RESET regulators
and the NOP PHY devices.

Signed-off-by: Roger Quadros <rogerq at ti.com>
---
 arch/arm/mach-omap2/board-cm-t35.c |   20 ++++++++++++++------
 1 files changed, 14 insertions(+), 6 deletions(-)

diff --git a/arch/arm/mach-omap2/board-cm-t35.c b/arch/arm/mach-omap2/board-cm-t35.c
index af2bb21..7fda3f5 100644
--- a/arch/arm/mach-omap2/board-cm-t35.c
+++ b/arch/arm/mach-omap2/board-cm-t35.c
@@ -419,15 +419,22 @@ static struct omap2_hsmmc_info mmc[] = {
 	{}	/* Terminator */
 };
 
+static struct usbhs_phy_data phy_data[] __initdata = {
+	{
+		.port = 1,
+		.reset_gpio = OMAP_MAX_GPIO_LINES + 6,
+		.vcc_gpio = -EINVAL,
+	},
+	{
+		.port = 2,
+		.reset_gpio = OMAP_MAX_GPIO_LINES + 7,
+		.vcc_gpio = -EINVAL,
+	},
+};
+
 static struct usbhs_omap_platform_data usbhs_bdata __initdata = {
 	.port_mode[0] = OMAP_EHCI_PORT_MODE_PHY,
 	.port_mode[1] = OMAP_EHCI_PORT_MODE_PHY,
-	.port_mode[2] = OMAP_USBHS_PORT_MODE_UNUSED,
-
-	.phy_reset  = true,
-	.reset_gpio_port[0]  = OMAP_MAX_GPIO_LINES + 6,
-	.reset_gpio_port[1]  = OMAP_MAX_GPIO_LINES + 7,
-	.reset_gpio_port[2]  = -EINVAL
 };
 
 static void  __init cm_t35_init_usbh(void)
@@ -444,6 +451,7 @@ static void  __init cm_t35_init_usbh(void)
 		msleep(1);
 	}
 
+	usbhs_init_phys(phy_data, ARRAY_SIZE(phy_data));
 	usbhs_init(&usbhs_bdata);
 }
 
-- 
1.7.4.1