[PATCH 0/8] ARM: OMAP3+: Switch to use DT based cpu0-cpufreq driver

[Nishanth Menon]

On 16:42-20130314, Jon Hunter wrote:
> 
> On 03/14/2013 03:58 PM, Nishanth Menon wrote:
> > The following series arose from trying to use BeagleBoard-XM (OMAP3 variant)
> > for doing CPU DVFS using cpufreq-cpu0. This series will eventually result in
> > migrating the cpufreq support only through device tree (part of the effort
> > to migrate away from non-DT configurations for OMAP). Unfortunately, as already
> > known, we have a bunch of legacy code and mutually dependent device tree
> > conversion that is pending.
> > Key features pending:
> > A) clock framework transition to DT - this should happen soon, so this series hacks
> > the clock node for the time being as suggested in review of original series
> > B) on processors that use voltage controller, voltage processor (VC/VP hardware
> > loop using I2C_SR path) - we have started work on transitioning them to regulator
> > framework driven by DT.
> > C) Adaptive Body Bias and SmartReflex AVS conversion to DT.
> > 
> > As a result of these pending features:
> > - OMAP4 TWL6030 and TPS62361 which set voltage ONLY over I2C_SR have no regulators
> > associated at the moment - fortunately, we boot at highest voltage, so things still
> > work.
> > - Missing ABB and AVS implies that for few of the SoCs (3630, OMAP4), I have not added
> > those OPPs in DT yet - this also needs alignment with iMX, AM series like pending work,
> > where certain OPPs need enabling based on efuse programmed bit sequences - since it
> > is an add-on work, it is not addressed here.
> > 
> > Note: Somewhere in the future, when we have regulators driven off CCF and OMAP
> > converted to CCF, we could remove the DT regulator requirements there as well.
> 
> OMAP has been converted to the common clock framework (CCF). Are you
> referring to clock framework transition to DT or something else?
I should have been explicit here - we do not have DT entries for clock
nodes for OMAP. For example, compare:
git grep clocks arch/arm/boot/dts/omap*.dts*
Vs
git grep clocks arch/arm/boot/dts/imx*.dts*

The specific comment above was intended to see the following series
equivalent in upstream:

https://patchwork.kernel.org/patch/2195431/
https://patchwork.kernel.org/patch/2195421/
https://patchwork.kernel.org/patch/2195451/
https://patchwork.kernel.org/patch/2195441/
https://patchwork.kernel.org/patch/2195461/

-- 
Regards,
Nishanth Menon