[PATCH v2 1/4] spi/davinci: add DT binding documentation
Arnd Bergmann
arnd at arndb.de
Tue Mar 5 14:32:41 EST 2013
On Tuesday 05 March 2013, Manjunathappa, Prakash wrote:
> On Mon, Mar 04, 2013 at 21:59:16, Arnd Bergmann wrote:
> > On Monday 04 March 2013 18:29:12 Manjunathappa, Prakash wrote:
> > > +- reg: Offset and length of SPI controller register space
> > > +- num-cs: Number of chip selects
> > > +- ti,davinci-spi-intr-line: interrupt line used to connect the SPI
> > > + IP to the interrupt controller withn the SoC. Possible values
> > > + are 0 and 1. Manual says one of the two possible interrupt
> > > + lines can be tied to the interrupt controller. Set this
> > > + based on a specifc SoC configuration.
> > > +- interrupts: interrupt number offset at the irq parent
> >
> > I would not call this an "offset". It is an interrupt descriptor
> > which may be something other than a simple number.
> >
>
> I am planning to drop from this documentation as it is common property.
I think it makese sense to document the fact that there should be exactly
one interrupt listed in the interrupts property, especially since the
hardware has two outputs.
Arnd
More information about the linux-arm-kernel
mailing list