[PATCH 05/15] ARM: OMAP5: PM: Enables ES2 PM mode by default
Nishanth Menon
nm at ti.com
Fri Mar 1 14:37:45 EST 2013
On 17:40-20130301, Santosh Shilimkar wrote:
> Enables MPUSS ES2 power management mode using ES2_PM_MODE in
> AMBA_IF_MODE register.
>
> 0x0: ES1 behavior, CPU cores would enter and exit OFF mode together. Broken
> 0x1: ES2 behavior, CPU cores are allowed to enter/exit OFF mode independently.
>
> This is one time settings thanks to always ON domain.
>
> Signed-off-by: Santosh Shilimkar <santosh.shilimkar at ti.com>
> ---
> arch/arm/mach-omap2/omap-secure.h | 2 ++
> arch/arm/mach-omap2/omap-wakeupgen.c | 14 ++++++++++++++
> arch/arm/mach-omap2/omap-wakeupgen.h | 1 +
> 3 files changed, 17 insertions(+)
>
> diff --git a/arch/arm/mach-omap2/omap-secure.h b/arch/arm/mach-omap2/omap-secure.h
> index 0e72917..82b3c4c 100644
> --- a/arch/arm/mach-omap2/omap-secure.h
> +++ b/arch/arm/mach-omap2/omap-secure.h
> @@ -42,6 +42,8 @@
> #define OMAP4_MON_L2X0_AUXCTRL_INDEX 0x109
> #define OMAP4_MON_L2X0_PREFETCH_INDEX 0x113
>
> +#define OMAP5_MON_AMBA_IF_INDEX 0x108
> +
> /* Secure PPA(Primary Protected Application) APIs */
> #define OMAP4_PPA_L2_POR_INDEX 0x23
> #define OMAP4_PPA_CPU_ACTRL_SMP_INDEX 0x25
> diff --git a/arch/arm/mach-omap2/omap-wakeupgen.c b/arch/arm/mach-omap2/omap-wakeupgen.c
> index 5d3b4f4..a7350dd 100644
> --- a/arch/arm/mach-omap2/omap-wakeupgen.c
> +++ b/arch/arm/mach-omap2/omap-wakeupgen.c
> @@ -403,6 +403,7 @@ int __init omap_wakeupgen_init(void)
> {
> int i;
> unsigned int boot_cpu = smp_processor_id();
> + u32 val;
>
> /* Not supported on OMAP4 ES1.0 silicon */
> if (omap_rev() == OMAP4430_REV_ES1_0) {
> @@ -444,6 +445,19 @@ int __init omap_wakeupgen_init(void)
> for (i = 0; i < max_irqs; i++)
> irq_target_cpu[i] = boot_cpu;
>
> + /*
> + * Enables OMAP5 ES2 PM Mode using ES2_PM_MODE in AMBA_IF_MODE
> + * 0x0: ES1 behavior, CPU cores would enter and exit OFF mode together.
> + * 0x1: ES2 behavior, CPU cores are allowed to enter/exit OFF mode
> + * independently.
> + * This needs to be set one time thanks to always ON domain.
> + */
> + if (soc_is_omap54xx()) {
> + val = __raw_readl(wakeupgen_base + OMAP_AMBA_IF_MODE);
> + val |= BIT(5);
BIT(5) is ES2_PM_MODE for es2.0 only - we dont have a OMAP5 revision check atm.
maybe
> + omap_smc1(OMAP5_MON_AMBA_IF_INDEX, val);
> + }
> +
> irq_hotplug_init();
> irq_pm_init();
>
> diff --git a/arch/arm/mach-omap2/omap-wakeupgen.h b/arch/arm/mach-omap2/omap-wakeupgen.h
> index b0fd16f..b3c8ecc 100644
> --- a/arch/arm/mach-omap2/omap-wakeupgen.h
> +++ b/arch/arm/mach-omap2/omap-wakeupgen.h
> @@ -27,6 +27,7 @@
> #define OMAP_WKG_ENB_E_1 0x420
> #define OMAP_AUX_CORE_BOOT_0 0x800
> #define OMAP_AUX_CORE_BOOT_1 0x804
> +#define OMAP_AMBA_IF_MODE 0x80c
> #define OMAP_PTMSYNCREQ_MASK 0xc00
> #define OMAP_PTMSYNCREQ_EN 0xc04
> #define OMAP_TIMESTAMPCYCLELO 0xc08
Curious, I see OMAP5_AMBA_IF_MODE_OFFSET in
arch/arm/mach-omap2/omap4-sar-layout.h
if we dont save new modified contents there, Wont restore logic just
reset it back to 0?
--
Regards,
Nishanth Menon
More information about the linux-arm-kernel
mailing list