[RFC PATCH 26/50] ARM: at91/tc/clocksource: replace clk_enable/disable with clk_prepare_enable/disable_unprepare.

[Boris BREZILLON]

Replace clk_enable/disable with clk_prepare_enable/disable_unprepare to
avoid common clk framework warnings.

Signed-off-by: Boris BREZILLON <b.brezillon at overkiz.com>
---
 drivers/clocksource/tcb_clksrc.c |   10 +++++-----
 1 file changed, 5 insertions(+), 5 deletions(-)

diff --git a/drivers/clocksource/tcb_clksrc.c b/drivers/clocksource/tcb_clksrc.c
index 8a61872..229c019 100644
--- a/drivers/clocksource/tcb_clksrc.c
+++ b/drivers/clocksource/tcb_clksrc.c
@@ -100,7 +100,7 @@ static void tc_mode(enum clock_event_mode m, struct clock_event_device *d)
 			|| tcd->clkevt.mode == CLOCK_EVT_MODE_ONESHOT) {
 		__raw_writel(0xff, regs + ATMEL_TC_REG(2, IDR));
 		__raw_writel(ATMEL_TC_CLKDIS, regs + ATMEL_TC_REG(2, CCR));
-		clk_disable(tcd->clk);
+		clk_disable_unprepare(tcd->clk);
 	}
 
 	switch (m) {
@@ -109,7 +109,7 @@ static void tc_mode(enum clock_event_mode m, struct clock_event_device *d)
 	 * of oneshot, we get lower overhead and improved accuracy.
 	 */
 	case CLOCK_EVT_MODE_PERIODIC:
-		clk_enable(tcd->clk);
+		clk_prepare_enable(tcd->clk);
 
 		/* slow clock, count up to RC, then irq and restart */
 		__raw_writel(timer_clock
@@ -126,7 +126,7 @@ static void tc_mode(enum clock_event_mode m, struct clock_event_device *d)
 		break;
 
 	case CLOCK_EVT_MODE_ONESHOT:
-		clk_enable(tcd->clk);
+		clk_prepare_enable(tcd->clk);
 
 		/* slow clock, count up to RC, then irq and stop */
 		__raw_writel(timer_clock | ATMEL_TC_CPCSTOP
@@ -275,7 +275,7 @@ static int __init tcb_clksrc_init(void)
 	pdev = tc->pdev;
 
 	t0_clk = tc->clk[0];
-	clk_enable(t0_clk);
+	clk_prepare_enable(t0_clk);
 
 	/* How fast will we be counting?  Pick something over 5 MHz.  */
 	rate = (u32) clk_get_rate(t0_clk);
@@ -313,7 +313,7 @@ static int __init tcb_clksrc_init(void)
 		/* tclib will give us three clocks no matter what the
 		 * underlying platform supports.
 		 */
-		clk_enable(tc->clk[1]);
+		clk_prepare_enable(tc->clk[1]);
 		/* setup both channel 0 & 1 */
 		tcb_setup_dual_chan(tc, best_divisor_idx);
 	}
-- 
1.7.9.5