[PATCH 6/6] [RFC] arm: shmobile: genmai reference: Add RSPI nodes

[Laurent Pinchart]

Hi Geert,

On Friday 27 December 2013 20:08:18 Geert Uytterhoeven wrote:
> On Fri, Dec 27, 2013 at 5:20 PM, Laurent Pinchart wrote:
> > On Tuesday 24 December 2013 12:56:50 Geert Uytterhoeven wrote:
> >> Add pinctrl and SPI devices for RSPI on Genmai.
> >> 
> >> On this board, only rspi4 is in use. It's bus contains a single device
> >> (a wm8978 audio codec), for which no bindings are defined yet.
> >> 
> >> Signed-off-by: Geert Uytterhoeven <geert+renesas at linux-m68k.org>
> >> Cc: devicetree at vger.kernel.org
> >> ---
> >> 
> >>  arch/arm/boot/dts/r7s72100-genmai-reference.dts |   18 ++++++++++++++++-
> >>  1 file changed, 17 insertions(+), 1 deletion(-)
> >> 
> >> diff --git a/arch/arm/boot/dts/r7s72100-genmai-reference.dts
> >> b/arch/arm/boot/dts/r7s72100-genmai-reference.dts index
> >> 114510f8bf09..6d99630627e4 100644
> >> --- a/arch/arm/boot/dts/r7s72100-genmai-reference.dts
> >> +++ b/arch/arm/boot/dts/r7s72100-genmai-reference.dts
> >> @@ -43,7 +43,7 @@
> >>  };
> >>  
> >>  &pfc {
> >> -     pinctrl-0 = <&scif2_pins &ethernet_pins>;
> >> +     pinctrl-0 = <&scif2_pins &ethernet_pins &rspi4_pins>;
> > 
> > You should add pinctrl-0 and pinctrl-names properties to the spi4 node
> > instead. Device nodes should reference their pinctrl configuration
> > directly, scif2 and ethernet are exceptions as DT bindings for those
> > devices are not in mainline yet.
> 
> I put it there because the actual driver doesn't use DT yet. Is that OK?

I had missed that. That's fine, but shouldn't you then delay patch 5/6 until 
the driver gets DT support ?

You've already sent a DT bindings proposal (thanks for that !), wouldn't it 
make sense to implement support in the driver before this patch ? We're pretty 
close to that from what I can see.

-- 
Regards,

Laurent Pinchart