[PATCH v3 0/3] Introduce clocksource driver for Keystone platform

[Ivan Khoronzhuk]

Add a broadcast timer64 based clockevent driver for keystone arch.
This driver uses timer in 64-bit general purpose mode as clock event
device.

Documentation:
    http://www.ti.com/lit/ug/sprugv5a/sprugv5a.pdf

Based on
git://git.kernel.org/pub/scm/linux/kernel/git/ssantosh/linux-keystone.git
keystone/master

v2..v3:
- clocksource: timer-keystone: introduce clocksource driver for
	changed "u64" type to "unsigned long" for hz_period as more appropriate
	hz_period rounded up by DIV_ROUND_UP(rate, HZ)
	corrected comments

v1..v2:
- clocksource: timer-keystone: introduce clocksource driver for
	renamed timer on "timer-keystone"
	in keystone_timer_interrupt() evet pointer is passed via "dev_id"
	used __relaxed variants of writel/readl and added explicit barriers
	added "keystone_timer_disable()" for using in keystone_set_mode()
	keystone_timer_config() is not used for disabling the timer any more
	in case of an unsupported mode the keystone_timer_config() returns -1.
	used request_irq() instead of setup_irq()
	assigned irq for event_device in event_dev->irq
	calculated timer.hz_period for CLOCK_EVT_MODE_PERIODIC at init
	deleted spare call of keystone_timer_config() in keystone_timer_init()

Ivan Khoronzhuk (3):
  clocksource: timer-keystone: introduce clocksource driver for
    Keystone
  clocksource: keystone: add bindings for keystone timer
  arm: dts: keystone: add keystone timer entry

 .../bindings/timer/ti,keystone-timer.txt           |   29 +++
 arch/arm/boot/dts/keystone-clocks.dtsi             |   10 +
 arch/arm/boot/dts/keystone.dtsi                    |    7 +
 drivers/clocksource/Makefile                       |    1 +
 drivers/clocksource/timer-keystone.c               |  233 ++++++++++++++++++++
 5 files changed, 280 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/timer/ti,keystone-timer.txt
 create mode 100644 drivers/clocksource/timer-keystone.c

-- 
1.7.9.5