[PATCH v3] cpufreq: imx6q: add of_init_opp_table

[John Tobias]

Add a routine check to see if the platform supplied the OPP table.
Incase there's no OPP table exist, it will try to initialise it.

It's been tested on iMX6SL board where the platform doesn't have
an OPP table.

Signed-off-by: John Tobias <john.tobias.ph at gmail.com>
---
 drivers/cpufreq/imx6q-cpufreq.c | 21 +++++++++++++++++----
 1 file changed, 17 insertions(+), 4 deletions(-)

diff --git a/drivers/cpufreq/imx6q-cpufreq.c b/drivers/cpufreq/imx6q-cpufreq.c
index 4b3f18e..e125aed 100644
--- a/drivers/cpufreq/imx6q-cpufreq.c
+++ b/drivers/cpufreq/imx6q-cpufreq.c
@@ -187,12 +187,25 @@ static int imx6q_cpufreq_probe(struct platform_device *pdev)
 		goto put_node;
 	}
 
-	/* We expect an OPP table supplied by platform */
+	/*
+	 * We expect an OPP table supplied by platform.
+	 * Just, incase the platform did not supply the OPP
+	 * table, it will try to get it.
+	 */
 	num = dev_pm_opp_get_opp_count(cpu_dev);
 	if (num < 0) {
-		ret = num;
-		dev_err(cpu_dev, "no OPP table is found: %d\n", ret);
-		goto put_node;
+		ret = of_init_opp_table(cpu_dev);
+		if (ret < 0) {
+			dev_err(cpu_dev, "failed to init OPP table: %d\n", ret);
+			goto put_node;
+		}
+
+		num = dev_pm_opp_get_opp_count(cpu_dev);
+		if (num < 0) {
+			ret = num;
+			dev_err(cpu_dev, "no OPP table is found: %d\n", ret);
+			goto put_node;
+		}
 	}
 
 	ret = dev_pm_opp_init_cpufreq_table(cpu_dev, &freq_table);
-- 
1.8.3.2