[PATCH V1 1/7] ARM: dts: imx: pinfunc: add MX6QDL_PAD_GPIO_6__ENET_IRQ

[Troy Kisky]

On 12/18/2013 10:04 PM, Shawn Guo wrote:
> On Wed, Dec 18, 2013 at 03:41:31PM -0700, Troy Kisky wrote:
>> Quoting from Ranjani Vaidyanathan
>>
>> All of the interrupts from the ENET block are not routed to
>> the GPC block. Hence ENET interrupts are not able to wake
>> up the SOC when the system is in WAIT mode. And the ENET
>> interrupt gets serviced only when another interrupt causes
>> the SOC to exit WAIT mode. This impacts the ENET performance.
> We should probably also quote the IMX6Q errata document below.
>
>   http://cache.freescale.com/files/32bit/doc/errata/IMX6DQCE.pdf?fpsp=1
>
> ERR006687 ENET: Only the ENET wake-up interrupt request can wake the
> system from Wait mode.

Thanks for the link, I didn't know about rev 3. But since they say 
pretty much the same
things, should I only quote the manual ?

>> Adding MX6QDL_PAD_GPIO_6__ENET_IRQ is the 1st step to
>> workaround this problem.
>>
>> The input reg is set to 0x3c to set IOMUX_OBSRV_MUX1 to ENET_IRQ.
> It seems this is an undocumented register?  Is the info available
> somewhere?

I'm the wrong person to ask. The only reference I've seen are patches.
Mode 1 for GPIO_6 isn't documented either.

>
>> The mux reg value is 0x11, so that the observable mux is routed to
>> this pin and to the gpio controller(sion bit).
>>
>> Signed-off-by: Troy Kisky <troy.kisky at boundarydevices.com>
>> CC: ra5478 at freescale.com
> When having people in the tag, please put their name in there as well,
> so Ranjani Vaidyanathan <ra5478 at freescale.com> please.
>
> Shawn
>
Will do,

Thanks
Troy