[PATCH 1/2] ARM: tegra: fix missing pincontrol configuration for Venice2

[Laxman Dewangan]

On Thursday 19 December 2013 02:26 AM, Stephen Warren wrote:
> On 12/18/2013 05:52 AM, Laxman Dewangan wrote:
>> Compare the initial population of default pinmux configuration of Venice2
>> with the chrome branch and add/fix the missing configurations.
> Wow, that's a big chunk of changes. Are you sure this is correct? Why
> was the original patch (which added the pinctrl nodes) so incorrect?

The pinmux which got added is based on the venice2 pinmux spreadsheet 
where I covered only the SFIO pin groups.

https://wiki.nvidia.com/engwiki/index.php/Platform_Design_Center/Projects_Archive/PM371#pinmux


After comparing with the chrome, I also added the pinmux for all pins 
which are used as GPIO and hence the change is big.
This is complete pinmux based on chrome kernel-next.
I booted chrome with this pinmux and not observe any behavioral change.

> Thierry, I thought you had mentioned comparing the pinctrl setup in
> linux-next with the downstream kernel for Venice2 and only found a
> difference in the PWM settings, which you sent a patch for. However,
> this patch is much larger than that. Where's the disconnect?