[PATCH 3/4] SATA: MV: Add support for the optional PHYs

[Andrew Lunn]

Some Marvell SoCs have a SATA PHY which can be powered off, in order
to save power. Make use of the generic phy framework to control these
phys.

Signed-off-by: Andrew Lunn <andrew at lunn.ch>
---
v2->v3
Look for phys using name "port0", "port1", etc.
---
 drivers/ata/sata_mv.c | 20 ++++++++++++++++++++
 1 file changed, 20 insertions(+)

diff --git a/drivers/ata/sata_mv.c b/drivers/ata/sata_mv.c
index 56be31819897..896725bb5e34 100644
--- a/drivers/ata/sata_mv.c
+++ b/drivers/ata/sata_mv.c
@@ -60,6 +60,7 @@
 #include <linux/dma-mapping.h>
 #include <linux/device.h>
 #include <linux/clk.h>
+#include <linux/phy/phy.h>
 #include <linux/platform_device.h>
 #include <linux/ata_platform.h>
 #include <linux/mbus.h>
@@ -563,6 +564,12 @@ struct mv_host_priv {
 	struct clk		*clk;
 	struct clk              **port_clks;
 	/*
+	 * Some devices have a SATA PHY which can be enabled/disabled
+	 * in order to save power. These are optional: if the platform
+	 * devices does not have any phy, they won't be used.
+	 */
+	struct phy		**port_phys;
+	/*
 	 * These consistent DMA memory pools give us guaranteed
 	 * alignment for hardware-accessed data structures,
 	 * and less memory waste in accomplishing the alignment.
@@ -4076,6 +4083,11 @@ static int mv_platform_probe(struct platform_device *pdev)
 					GFP_KERNEL);
 	if (!hpriv->port_clks)
 		return -ENOMEM;
+	hpriv->port_phys = devm_kzalloc(&pdev->dev,
+					sizeof(struct phy *) * n_ports,
+					GFP_KERNEL);
+	if (!hpriv->port_phys)
+		return -ENOMEM;
 	host->private_data = hpriv;
 	hpriv->n_ports = n_ports;
 	hpriv->board_idx = chip_soc;
@@ -4097,6 +4109,10 @@ static int mv_platform_probe(struct platform_device *pdev)
 		hpriv->port_clks[port] = clk_get(&pdev->dev, port_number);
 		if (!IS_ERR(hpriv->port_clks[port]))
 			clk_prepare_enable(hpriv->port_clks[port]);
+		sprintf(port_number, "port%d", port);
+		hpriv->port_phys[port] = devm_phy_get(&pdev->dev, port_number);
+		if (!IS_ERR(hpriv->port_phys[port]))
+			phy_power_on(hpriv->port_phys[port]);
 	}
 
 	/*
@@ -4132,6 +4148,8 @@ err:
 			clk_disable_unprepare(hpriv->port_clks[port]);
 			clk_put(hpriv->port_clks[port]);
 		}
+		if (!IS_ERR(hpriv->port_phys[port]))
+			phy_power_off(hpriv->port_phys[port]);
 	}
 
 	return rc;
@@ -4161,6 +4179,8 @@ static int mv_platform_remove(struct platform_device *pdev)
 			clk_disable_unprepare(hpriv->port_clks[port]);
 			clk_put(hpriv->port_clks[port]);
 		}
+		if (!IS_ERR(hpriv->port_phys[port]))
+			phy_power_off(hpriv->port_phys[port]);
 	}
 	return 0;
 }
-- 
1.8.5.1