[PATCH v3 9/9] mtd: nand: davinci: don't request AEMIF address range

[Brian Norris]

On Thu, Dec 05, 2013 at 07:25:57PM +0200, Ivan Khoronzhuk wrote:
> The TI AEMIF driver registers are used to setup timings for each chip
> select. The same registers range is used to setup NAND settings.
> The AEMIF and NAND drivers not use the same registers in this range.
> 
> In case with TI AEMIF driver, the memory address range is requested
> already by AEMIF, so we cannot request it twice, just ioremap.
> 
> Acked-by: Santosh Shilimkar <santosh.shilimkar at ti.com>
> Reviewed-by: Grygorii Strashko <grygorii.strashko at ti.com>
> Reviewed-by: Taras Kondratiuk <taras at ti.com>
> Signed-off-by: Ivan Khoronzhuk <ivan.khoronzhuk at ti.com>
> ---
>  drivers/mtd/nand/davinci_nand.c |    8 +++++---
>  1 file changed, 5 insertions(+), 3 deletions(-)
> 
> diff --git a/drivers/mtd/nand/davinci_nand.c b/drivers/mtd/nand/davinci_nand.c
> index f7b21b8..0cd4dbc 100644
> --- a/drivers/mtd/nand/davinci_nand.c
> +++ b/drivers/mtd/nand/davinci_nand.c
> @@ -636,9 +636,11 @@ static int __init nand_davinci_probe(struct platform_device *pdev)
>  	if (IS_ERR(vaddr))
>  		return PTR_ERR(vaddr);
>  
> -	base = devm_ioremap_resource(&pdev->dev, res2);
> -	if (IS_ERR(base))
> -		return PTR_ERR(base);
> +	base = devm_ioremap(&pdev->dev, res2->start, resource_size(res2));

Since it's important that we don't re-introduce the "request resource"
boilerplate later, can you add a comment describing the situation?

> +	if (!base) {
> +		dev_err(&pdev->dev, "ioremap failed for resource %pR\n", res2);
> +		return -EADDRNOTAVAIL;
> +	}
>  
>  	info->dev		= &pdev->dev;
>  	info->base		= base;

Thanks,
Brian