[PATCH V2 06/13] ARM: dts: imx6qdl-sabrelite: move phy reset to pinctrl_enet

[Troy Kisky]

This patch moves pin EIM_D23 (phy reset) from pinctrl_hog to pinctrl_enet.
It also explicitly sets the pad to 0x000b0.

Before this patch, it has the value 0x1b0b0 if using mainline u-boot.
So this patch also removes hysteresis and a 100K pullup since the pad
is always an output.

Signed-off-by: Troy Kisky <troy.kisky at boundarydevices.com>

---
v2: New patch.. V1 patch to add comments was broken up into
multiple patches
---
 arch/arm/boot/dts/imx6qdl-sabrelite.dtsi | 7 +++++--
 1 file changed, 5 insertions(+), 2 deletions(-)

diff --git a/arch/arm/boot/dts/imx6qdl-sabrelite.dtsi b/arch/arm/boot/dts/imx6qdl-sabrelite.dtsi
index 2654ff1..ee3f5c0 100644
--- a/arch/arm/boot/dts/imx6qdl-sabrelite.dtsi
+++ b/arch/arm/boot/dts/imx6qdl-sabrelite.dtsi
@@ -114,7 +114,6 @@
 	imx6q-sabrelite {
 		pinctrl_hog: hoggrp {
 			fsl,pins = <
-				MX6QDL_PAD_EIM_D23__GPIO3_IO23  0x80000000
 				MX6QDL_PAD_GPIO_0__CCM_CLKO1    0x80000000
 			>;
 		};
@@ -131,7 +130,11 @@
 		};
 
 		pinctrl_enet: enetgrp {
-			fsl,pins = <MX6QDL_ENET_PINGRP1>;
+			fsl,pins = <
+				MX6QDL_ENET_PINGRP1
+				/* Phy reset */
+				MX6QDL_PAD_EIM_D23__GPIO3_IO23		0x000b0
+			>;
 		};
 
 		pinctrl_i2c1: i2c1grp {
-- 
1.8.1.2