[PATCH V2 5/7] PCI: imx6: Fix link start operation

[Marek Vasut]

This patch first forces the link into Gen1 mode before starting up
the link and only after the link is up requests the link to start
negotiating possible Gen2 mode operation. This is because without
such sequence, some PCIe switches are not detected at all.

Signed-off-by: Marek Vasut <marex at denx.de>
Cc: Bjorn Helgaas <bhelgaas at google.com>
Cc: Frank Li <lznuaa at gmail.com>
Cc: Harro Haan <hrhaan at gmail.com>
Cc: Jingoo Han <jg1.han at samsung.com>
Cc: Mohit KUMAR <Mohit.KUMAR at st.com>
Cc: Pratyush Anand <pratyush.anand at st.com>
Cc: Richard Zhu <r65037 at freescale.com>
Cc: Sascha Hauer <s.hauer at pengutronix.de>
Cc: Sean Cross <xobs at kosagi.com>
Cc: Shawn Guo <shawn.guo at linaro.org>
Cc: Siva Reddy Kallam <siva.kallam at samsung.com>
Cc: Srikanth T Shivanand <ts.srikanth at samsung.com>
Cc: Tim Harvey <tharvey at gateworks.com>
Cc: Troy Kisky <troy.kisky at boundarydevices.com>
Cc: Yinghai Lu <yinghai at kernel.org>
---
 drivers/pci/host/pci-imx6.c | 78 +++++++++++++++++++++++++++++++++++++++++----
 1 file changed, 72 insertions(+), 6 deletions(-)

V2: Change the link speed reporting from dev_err() to dev_dbg() so it doesn't
    polute the kernel output.

diff --git a/drivers/pci/host/pci-imx6.c b/drivers/pci/host/pci-imx6.c
index 4d6f6fe..3028f2c 100644
--- a/drivers/pci/host/pci-imx6.c
+++ b/drivers/pci/host/pci-imx6.c
@@ -44,6 +44,12 @@ struct imx6_pcie {
 	void __iomem		*mem_base;
 };
 
+/* PCIe Root Complex registers (memory-mapped) */
+#define PCIE_RC_LCR				0x7c
+#define PCIE_RC_LCR_MAX_LINK_SPEEDS_GEN1	0x1
+#define PCIE_RC_LCR_MAX_LINK_SPEEDS_GEN2	0x2
+#define PCIE_RC_LCR_MAX_LINK_SPEEDS_MASK	0xf
+
 /* PCIe Port Logic registers (memory-mapped) */
 #define PL_OFFSET 0x700
 #define PCIE_PHY_DEBUG_R0 (PL_OFFSET + 0x28)
@@ -61,6 +67,9 @@ struct imx6_pcie {
 #define PCIE_PHY_STAT (PL_OFFSET + 0x110)
 #define PCIE_PHY_STAT_ACK_LOC 16
 
+#define PCIE_LINK_WIDTH_SPEED_CONTROL	0x80C
+#define PORT_LOGIC_SPEED_CHANGE		(0x1 << 17)
+
 /* PHY registers (not memory-mapped) */
 #define PCIE_PHY_RX_ASIC_OUT 0x100D
 
@@ -323,11 +332,71 @@ static int imx6_pcie_wait_for_link(struct pcie_port *pp)
 	return 0;
 }
 
-static void imx6_pcie_host_init(struct pcie_port *pp)
+static int imx6_pcie_start_link(struct pcie_port *pp)
 {
-	int count = 0;
 	struct imx6_pcie *imx6_pcie = to_imx6_pcie(pp);
+	uint32_t tmp;
+	int ret, count;
+
+	/*
+	 * Force Gen1 operation when starting the link. In case the link is
+	 * started in Gen2 mode, there is a possibility the devices on the
+	 * bus will not be detected at all. This happens with PCIe switches.
+	 */
+	tmp = readl(pp->dbi_base + PCIE_RC_LCR);
+	tmp &= ~PCIE_RC_LCR_MAX_LINK_SPEEDS_MASK;
+	tmp |= PCIE_RC_LCR_MAX_LINK_SPEEDS_GEN1;
+	writel(tmp, pp->dbi_base + PCIE_RC_LCR);
+
+	/* Start LTSSM. */
+	regmap_update_bits(imx6_pcie->iomuxc_gpr, IOMUXC_GPR12,
+			IMX6Q_GPR12_PCIE_CTL_2, 1 << 10);
+
+	ret = imx6_pcie_wait_for_link(pp);
+	if (ret)
+		return ret;
+
+	/* Allow Gen2 mode after the link is up. */
+	tmp = readl(pp->dbi_base + PCIE_RC_LCR);
+	tmp &= ~PCIE_RC_LCR_MAX_LINK_SPEEDS_MASK;
+	tmp |= PCIE_RC_LCR_MAX_LINK_SPEEDS_GEN2;
+	writel(tmp, pp->dbi_base + PCIE_RC_LCR);
+
+	/*
+	 * Start Directed Speed Change so the best possible speed both link
+	 * partners support can be negotiated.
+	 */
+	tmp = readl(pp->dbi_base + PCIE_LINK_WIDTH_SPEED_CONTROL);
+	tmp |= PORT_LOGIC_SPEED_CHANGE;
+	writel(tmp, pp->dbi_base + PCIE_LINK_WIDTH_SPEED_CONTROL);
+
+	count = 200;
+	while (count--) {
+		tmp = readl(pp->dbi_base + PCIE_LINK_WIDTH_SPEED_CONTROL);
+		/* Test if the speed change finished. */
+		if (!(tmp & PORT_LOGIC_SPEED_CHANGE))
+			break;
+		usleep_range(100, 1000);
+	}
+
+	/* Make sure link training is finished as well! */
+	if (count)
+		ret = imx6_pcie_wait_for_link(pp);
+	else
+		ret = -EINVAL;
 
+	if (ret) {
+		dev_err(pp->dev, "Failed to bring link up!\n");
+	} else {
+		tmp = readl(pp->dbi_base + 0x80);
+		dev_dbg(pp->dev, "Link up, Gen=%i\n", (tmp >> 16) & 0xf);
+	}
+
+	return ret;
+}
+
+static void imx6_pcie_host_init(struct pcie_port *pp)
+{
 	imx6_pcie_assert_core_reset(pp);
 
 	imx6_pcie_init_phy(pp);
@@ -336,10 +405,7 @@ static void imx6_pcie_host_init(struct pcie_port *pp)
 
 	dw_pcie_setup_rc(pp);
 
-	regmap_update_bits(imx6_pcie->iomuxc_gpr, IOMUXC_GPR12,
-			IMX6Q_GPR12_PCIE_CTL_2, 1 << 10);
-
-	imx6_pcie_wait_for_link(pp);
+	imx6_pcie_start_link(pp);
 
 	return;
 }
-- 
1.8.4.3