[PATCH 1/2] gpio: msm: Fix irq mask/unmask by writing bits instead of numbers

[Stephen Boyd]

We should be writing bits here but instead we're writing the
numbers that correspond to the bits we want to write. Fix it by
wrapping the numbers in the BIT() macro. This fixes gpios acting
as interrupts.

Signed-off-by: Stephen Boyd <sboyd at codeaurora.org>
---
 drivers/gpio/gpio-msm-v2.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/gpio/gpio-msm-v2.c b/drivers/gpio/gpio-msm-v2.c
index f7a0cc4..00a0978 100644
--- a/drivers/gpio/gpio-msm-v2.c
+++ b/drivers/gpio/gpio-msm-v2.c
@@ -252,7 +252,7 @@ static void msm_gpio_irq_mask(struct irq_data *d)
 
 	spin_lock_irqsave(&tlmm_lock, irq_flags);
 	writel(TARGET_PROC_NONE, GPIO_INTR_CFG_SU(gpio));
-	clear_gpio_bits(INTR_RAW_STATUS_EN | INTR_ENABLE, GPIO_INTR_CFG(gpio));
+	clear_gpio_bits(BIT(INTR_RAW_STATUS_EN) | BIT(INTR_ENABLE), GPIO_INTR_CFG(gpio));
 	__clear_bit(gpio, msm_gpio.enabled_irqs);
 	spin_unlock_irqrestore(&tlmm_lock, irq_flags);
 }
@@ -264,7 +264,7 @@ static void msm_gpio_irq_unmask(struct irq_data *d)
 
 	spin_lock_irqsave(&tlmm_lock, irq_flags);
 	__set_bit(gpio, msm_gpio.enabled_irqs);
-	set_gpio_bits(INTR_RAW_STATUS_EN | INTR_ENABLE, GPIO_INTR_CFG(gpio));
+	set_gpio_bits(BIT(INTR_RAW_STATUS_EN) | BIT(INTR_ENABLE), GPIO_INTR_CFG(gpio));
 	writel(TARGET_PROC_SCORPION, GPIO_INTR_CFG_SU(gpio));
 	spin_unlock_irqrestore(&tlmm_lock, irq_flags);
 }
-- 
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
hosted by The Linux Foundation