[PATCH 2/3] ARM: dts: mxs: Add a new pin config for the usb0 ID.

[Denis Carikli]

Cc: Rob Herring <rob.herring at calxeda.com>
Cc: Pawel Moll <pawel.moll at arm.com>
Cc: Mark Rutland <mark.rutland at arm.com>
Cc: Stephen Warren <swarren at wwwdotorg.org>
Cc: Ian Campbell <ijc+devicetree at hellion.org.uk>
Cc: devicetree at vger.kernel.org
Cc: linux-arm-kernel at lists.infradead.org
Cc: Shawn Guo <shawn.guo at linaro.org>
Cc: Eric Bénard <eric at eukrea.com>
Signed-off-by: Denis Carikli <denis at eukrea.com>
---
 arch/arm/boot/dts/imx28.dtsi |   11 +++++++++++
 1 file changed, 11 insertions(+)

diff --git a/arch/arm/boot/dts/imx28.dtsi b/arch/arm/boot/dts/imx28.dtsi
index 93a7e79..8d39c42 100644
--- a/arch/arm/boot/dts/imx28.dtsi
+++ b/arch/arm/boot/dts/imx28.dtsi
@@ -822,6 +822,17 @@
 					fsl,voltage = <MXS_VOLTAGE_HIGH>;
 					fsl,pull-up = <MXS_PULL_ENABLE>;
 				};
+
+				usb0_id_pins_b: usb0id1 at 0 {
+					reg = <0>;
+					fsl,pinmux-ids = <
+						MX28_PAD_PWM2__USB0_ID
+					>;
+					fsl,drive-strength = <MXS_DRIVE_12mA>;
+					fsl,voltage = <MXS_VOLTAGE_HIGH>;
+					fsl,pull-up = <MXS_PULL_ENABLE>;
+				};
+
 			};
 
 			digctl: digctl at 8001c000 {
-- 
1.7.9.5