[PATCH v2] ARM: tegra: switch FUSE clock on before usage

[Stephen Warren]

On 12/04/2013 12:09 AM, Alexandre Courbot wrote:
> Hi Stephen,
> 
> On Fri, Nov 22, 2013 at 10:35 AM, Alex Courbot <acourbot at nvidia.com> wrote:
>> On 11/22/2013 05:30 AM, Stephen Warren wrote:
>>>
>>> On 11/20/2013 07:40 PM, Alexandre Courbot wrote:
>>>>
>>>> FUSE clock is enabled by most bootloaders, but we cannot expect it to be
>>>> on in all contexts (e.g. kexec).
>>>>
>>>> Ensure the FUSE clock is enabled before any of its registers is touched.
>>>> Since FUSE is touched very early during system boot (before the clock
>>>> devices are registered), directly manipulate the clock register bit in
>>>> case the clock device cannot be acquired.
>>>
>>>
>>> This looks reasonable to me. I'll apply it soon after -rc1.
>>
>>
>> Thanks. Be careful as I noticed I misformatted my commit message. The part
>> after the "--" will not be stripped by git am as I intended it to be. I
>> understood what I did wrong and will hopefully not make that mistake again.
>>
>> Sorry for the inconvenience.
> 
> I am not seeing this in your tree, have you applied it somewhere already?

I haven't applied anything for 3.14 yet. I was hoping to get the
DMA/clock/reset DT binding rework in first, but it's been dragging on
for while, so I'll probably take a look at what can be applied without
conflicting with that soon.