[PATCH] ARM: dts: omap3-beagle: Fix USB host on beagle boards (for 3.13)

[Roger Quadros]

Hi Laurent,

On 12/03/2013 05:54 AM, Laurent Pinchart wrote:
> Hi Roger,
> 
> On Monday 25 November 2013 15:55:45 Roger Quadros wrote:
>> Beagle (rev. C4) and Beagle-XM (all revs) need VAUX2 1.8V supply
>> for the USB PHY.
>>
>> As the generic PHY driver can't handle more than one supply
>> at the moment, we configure this supply to be always on.
>> This will cause a very small power impact if the USB host subsystem
>> is not in use, about 76.86 micro-W + LDO power.
>>
>> Older Beagle boards (prior to C4) don't have VAUX2 connected anywhere,
>> so there won't be any functional impact on those boards other than
>> some additional LDO power consumption.
> 
> Do I need any patch other than this one (on top of v3.13-rc1) to enable the
> ethernet port on a Beagleboard-xM rev B ? Here's what the kernel reports at
> boot (with ignore_loglevel set on the command line).
> 

It seems on Rev A/B, the power enable line for the USB hub has reversed polarity
than Rev C.

Does the below patch work for you?

If yes, how do we account for it? Do we add a new file "omap3-beagle-xm-ab.dts" for
rev A/B boards?

cheers,
-roger

diff --git a/arch/arm/boot/dts/omap3-beagle-xm.dts b/arch/arm/boot/dts/omap3-beagle-xm.dts
index b39918e..434d903 100644
--- a/arch/arm/boot/dts/omap3-beagle-xm.dts
+++ b/arch/arm/boot/dts/omap3-beagle-xm.dts
@@ -78,6 +78,7 @@
 		regulator-max-microvolt = <3300000>;
 		gpio = <&twl_gpio 18 0>;	/* GPIO LEDA */
 		startup-delay-us = <70000>;
+		enable-active-high;
 	};
 
 	/* HS USB Host PHY on PORT 2 */