[alsa-devel] [PATCH 1/3] ASoC: ux500_pcm: Stop pretending that we support varying address widths

[Lars-Peter Clausen]

On 12/02/2013 07:00 PM, Lee Jones wrote:
> The Slave Config's addr_width attribute is populated by data_width of
> dma_cfg, which in turn is derived from dma_params' data_size attribute
> and that comes from the slot_width which is always 16 bits (2 Bytes).
> We're cutting out the middle man here and just setting the DMA Slave
> Config directly.
> 
> Cc: alsa-devel at alsa-project.org
> Signed-off-by: Lee Jones <lee.jones at linaro.org>

Patch looks good. But as a follow up patch I think you can now switch to the
generic snd_dmaengine_pcm_prepare_slave_config.

> ---
>  sound/soc/ux500/ux500_pcm.c | 13 ++++++-------
>  1 file changed, 6 insertions(+), 7 deletions(-)
> 
> diff --git a/sound/soc/ux500/ux500_pcm.c b/sound/soc/ux500/ux500_pcm.c
> index 6162f70..2f1bdb7 100644
> --- a/sound/soc/ux500/ux500_pcm.c
> +++ b/sound/soc/ux500/ux500_pcm.c
> @@ -104,26 +104,25 @@ static int ux500_pcm_prepare_slave_config(struct snd_pcm_substream *substream,
>  		struct dma_slave_config *slave_config)
>  {
>  	struct snd_soc_pcm_runtime *rtd = substream->private_data;
> -	struct ux500_msp_dma_params *dma_params;
> -	struct stedma40_chan_cfg *dma_cfg;
> +	struct snd_dmaengine_dai_dma_data *dma_params;
>  	int ret;
>  
>  	dma_params = snd_soc_dai_get_dma_data(rtd->cpu_dai, substream);
> -	dma_cfg = dma_params->dma_cfg;
>  
>  	ret = snd_hwparams_to_dma_slave_config(substream, params, slave_config);
>  	if (ret)
>  		return ret;
>  
>  	slave_config->dst_maxburst = 4;
> -	slave_config->dst_addr_width = dma_cfg->dst_info.data_width;
>  	slave_config->src_maxburst = 4;
> -	slave_config->src_addr_width = dma_cfg->src_info.data_width;
> +
> +	slave_config->src_addr_width = DMA_SLAVE_BUSWIDTH_2_BYTES;
> +	slave_config->dst_addr_width = DMA_SLAVE_BUSWIDTH_2_BYTES;
>  
>  	if (substream->stream == SNDRV_PCM_STREAM_PLAYBACK)
> -		slave_config->dst_addr = dma_params->tx_rx_addr;
> +		slave_config->dst_addr = dma_params->addr;
>  	else
> -		slave_config->src_addr = dma_params->tx_rx_addr;
> +		slave_config->src_addr = dma_params->addr;
>  
>  	return 0;
>  }
>