[PATCH 2/9] ARM: at91/dt: add ethernet phy to at91rm9200ek board

[Boris BREZILLON]

Add ethernet phy node in at91rm9200ek.dts.
The reg register is not specified, as it may differ depending on the init
process of the board:
ADDR0/1 phy pins are connected to PA13/14 rm9200 pins. Which means the phy
will take its address from these pins during the reset process.

The macb driver will launch a full scan on the mdio bus to discover the phy
address.

Signed-off-by: Boris BREZILLON <b.brezillon at overkiz.com>
---
 arch/arm/boot/dts/at91rm9200ek.dts |    5 +++++
 1 file changed, 5 insertions(+)

diff --git a/arch/arm/boot/dts/at91rm9200ek.dts b/arch/arm/boot/dts/at91rm9200ek.dts
index d2d72c3..37b0880 100644
--- a/arch/arm/boot/dts/at91rm9200ek.dts
+++ b/arch/arm/boot/dts/at91rm9200ek.dts
@@ -47,6 +47,11 @@
 			macb0: ethernet at fffbc000 {
 				phy-mode = "rmii";
 				status = "okay";
+
+				phy0: ethernet-phy {
+					interrupt-parent = <&pioC>;
+					interrupts = <4 IRQ_TYPE_EDGE_FALLING>;
+				};
 			};
 
 			usb1: gadget at fffb0000 {
-- 
1.7.9.5