MVEBU and MVNETA driver

[Greg]

Le 22/04/2013 11:08, Willy Tarreau a écrit :
> On Mon, Apr 22, 2013 at 10:19:41AM +0200, Greg wrote:
>> I'm using SLAB allocator.
>> As for offloading, I can't seem to be able to turn it on :
>>> $ ethtool -K eth0 gro on
>>> Cannot set device GRO settings: Operation not supported
>>> $ ethtool -K eth0 gso on
>>> Cannot set device generic segmentation offload settings: Operation not
>>> supported
>> Default values :
>>> $ ethtool -k eth0
>>> Offload parameters for eth0:
>>> rx-checksumming: off
>>> tx-checksumming: on
>>> scatter-gather: on
>>> tcp-segmentation-offload: off
>>> udp-fragmentation-offload: off
>>> generic-segmentation-offload: off
>>> generic-receive-offload: off
>>> large-receive-offload: off
>>> rx-vlan-offload: off
>>> tx-vlan-offload: off
>>> ntuple-filters: off
>>> receive-hashing: off
>> I can see 1 difference between our setups, Mirabox has an Armada370, I
>> have an ArmadaXP, it would be interesting to know what Gregory is using.
> OK so I guess you have a kernel version prior to 3.9-rc7. There is a bug
> in the driver which causes it to report tx cksum and sg but they're not
> enabled. You need to disable then enable them :
>
>    ethtool -K eth0 tx off
>    ethtool -K eth0 sg off
>    ethtool -K eth0 tx on
>    ethtool -K eth0 sg on
>
> Then you can enable gso/gro. And that clearly explains a significant
> performance difference.
Yes, as explain in my original mail, I'm using 3.8.8
I followed your recommendations and performance is now ~930-940Mbits in 
both directions which is fine.
Thanks !
>> Another difference on my setup, and something I wanted to report you :
>> there is no PHY on my system. I had to instantiate a dummy PHY in the
>> device tree blob and bind it to the mvneta driver because it would fail
>> at init without PHY.
> I think this is more something for Thomas then.
>
The "failure" is located in mvneta_mdio_probe but I guess this is more 
like an architectural problem.
The MVNETA driver assumes a PHY is present, but this is not a 
requirement to establish link between 2 MACs.
I guess using a dummy PHY is a not-so-bad idea for my situation at this 
time.

Regards,