[REMINDER: PATCH 1/1] spi:clk: preparation for switch to common clock framework

Karicheri, Muralidharan m-karicheri2 at ti.com
Fri Sep 28 12:11:32 EDT 2012


>> -----Original Message-----
>> From: Karicheri, Muralidharan
>> Sent: Monday, September 17, 2012 12:42 PM
>> To: spi-devel-general at lists.sourceforge.net; linux-kernel at vger.kernel.org; davinci-linux-
>> open-source at linux.davincidsp.com; grant.likely at secretlab.ca; linux-arm-
>> kernel at lists.infradead.org
>> Cc: Chemparathy, Cyril; Karicheri, Muralidharan
>> Subject: [PATCH 1/1] spi:clk: preparation for switch to common clock framework
>> 
>> As a first step towards migrating davinci platforms to use common clock
>> framework, replace all instances of clk_enable() with clk_prepare_enable()
>> and clk_disable() with clk_disable_unprepare(). Until the platform is
>> switched to use the CONFIG_HAVE_CLK_PREPARE Kconfig variable, this just
>> adds a might_sleep() call and would work without any issues.
>> 
>> This will make it easy later to switch to common clk based implementation
>> of clk driver from DaVinci specific driver.
>> 
>> Signed-off-by: Murali Karicheri <m-karicheri2 at ti.com>
>> Reviewed-by: Mike Turquette <mturquette at linaro.org>
>> 
>> diff --git a/drivers/spi/spi-davinci.c b/drivers/spi/spi-davinci.c
>> index c1ec52d..3f54f9e 100644
>> --- a/drivers/spi/spi-davinci.c
>> +++ b/drivers/spi/spi-davinci.c
>> @@ -843,7 +843,7 @@ static int __devinit davinci_spi_probe(struct platform_device
>> *pdev)
>>  		ret = -ENODEV;
>>  		goto put_master;
>>  	}
>> -	clk_enable(dspi->clk);
>> +	clk_prepare_enable(dspi->clk);
>> 
>>  	master->bus_num = pdev->id;
>>  	master->num_chipselect = pdata->num_chipselect;
>> @@ -927,7 +927,7 @@ free_dma:
>>  	dma_release_channel(dspi->dma_rx);
>>  	dma_release_channel(dspi->dma_tx);
>>  free_clk:
>> -	clk_disable(dspi->clk);
>> +	clk_disable_unprepare(dspi->clk);
>>  	clk_put(dspi->clk);
>>  put_master:
>>  	spi_master_put(master);
>> @@ -963,7 +963,7 @@ static int __devexit davinci_spi_remove(struct platform_device
>> *pdev)
>> 
>>  	spi_bitbang_stop(&dspi->bitbang);
>> 
>> -	clk_disable(dspi->clk);
>> +	clk_disable_unprepare(dspi->clk);
>>  	clk_put(dspi->clk);
>>  	spi_master_put(master);
>>  	free_irq(dspi->irq, dspi);
>> --
>> 1.7.9.5

Could you please review and apply this patch to linux-next?

Murali Karicheri
Software Design Engineer




More information about the linux-arm-kernel mailing list