[PATCH 3/4] pinctrl/nomadik: use simple or linear IRQ domain

[Rob Herring]

On 09/27/2012 08:13 AM, Linus Walleij wrote:
> From: Linus Walleij <linus.walleij at linaro.org>
> 
> This alters the Nomadik pinctrl driver to:
> 
> - Call irqdomain_add_linear() for the DT case so we get
>   all independent from IRQ numbers in this case.
> - Call irqdomain_add_simple() for the legacy case, which
>   allocates the IRQ descriptors for the Nomadik pin controller
>   dynamically.
> 
> Cc: Lee Jones <lee.jones at linaro.org>
> Cc: Rob Herring <rob.herring at calxeda.com>
> Signed-off-by: Linus Walleij <linus.walleij at linaro.org>
> ---
>  drivers/pinctrl/pinctrl-nomadik.c | 16 +++++++++++++---
>  1 file changed, 13 insertions(+), 3 deletions(-)
> 
> diff --git a/drivers/pinctrl/pinctrl-nomadik.c b/drivers/pinctrl/pinctrl-nomadik.c
> index e031c84..6aab107 100644
> --- a/drivers/pinctrl/pinctrl-nomadik.c
> +++ b/drivers/pinctrl/pinctrl-nomadik.c
> @@ -1286,9 +1286,19 @@ static int __devinit nmk_gpio_probe(struct platform_device *dev)
>  
>  	platform_set_drvdata(dev, nmk_chip);
>  
> -	nmk_chip->domain = irq_domain_add_legacy(np, NMK_GPIO_PER_CHIP,
> -						NOMADIK_GPIO_TO_IRQ(pdata->first_gpio),
> -						0, &nmk_gpio_irq_simple_ops, nmk_chip);
> +	if (np) {
> +		/* The DT case will just grab a set of IRQ numbers */
> +		nmk_chip->domain = irq_domain_add_linear(np, NMK_GPIO_PER_CHIP,
> +				&nmk_gpio_irq_simple_ops, nmk_chip);


irq_start = -1;

if (!np)
	irq_start = NOMADIK_GPIO_TO_IRQ(pdata->first_gpio);

and then always call irq_domain_add_simple.

Rob

> +	} else {
> +		/* Non-DT legacy mode, use hardwired IRQ numbers */
> +		int irq_start;
> +
> +		irq_start = NOMADIK_GPIO_TO_IRQ(pdata->first_gpio);
> +		nmk_chip->domain = irq_domain_add_simple(NULL,
> +				NMK_GPIO_PER_CHIP, irq_start,
> +				&nmk_gpio_irq_simple_ops, nmk_chip);
> +	}
>  	if (!nmk_chip->domain) {
>  		dev_err(&dev->dev, "failed to create irqdomain\n");
>  		ret = -ENOSYS;
>