[PATCH] pinctrl/nomadik: allocate IRQ descriptors dynamically

[Linus Walleij]

From: Linus Walleij <linus.walleij at linaro.org>

This allocates the IRQ descriptors for the Nomadik pin controller
dynamically so that we don't have to rely on some other mechanism
doing it, and moving a step closer to a linear IRQ domain.

Cc: Rob Herring <rob.herring at calxeda.com>
Signed-off-by: Linus Walleij <linus.walleij at linaro.org>
---
 drivers/pinctrl/pinctrl-nomadik.c | 19 +++++++++++++++++--
 1 file changed, 17 insertions(+), 2 deletions(-)

diff --git a/drivers/pinctrl/pinctrl-nomadik.c b/drivers/pinctrl/pinctrl-nomadik.c
index 3dde653..29921d1 100644
--- a/drivers/pinctrl/pinctrl-nomadik.c
+++ b/drivers/pinctrl/pinctrl-nomadik.c
@@ -1185,6 +1185,8 @@ static int __devinit nmk_gpio_probe(struct platform_device *dev)
 	struct clk *clk;
 	int secondary_irq;
 	void __iomem *base;
+	int irq_start;
+	int irq_base;
 	int irq;
 	int ret;
 
@@ -1288,9 +1290,22 @@ static int __devinit nmk_gpio_probe(struct platform_device *dev)
 
 	platform_set_drvdata(dev, nmk_chip);
 
+	/*
+	 * Allocate descriptors and IRQ domain using the legacy model, this
+	 * should eventually be replaced with a linear IRQ domain as we get
+	 * independent from the irq numbers with the switch to device tree.
+	 */
+	irq_start = NOMADIK_GPIO_TO_IRQ(pdata->first_gpio);
+	irq_base = irq_alloc_descs(irq_start, 0, NMK_GPIO_PER_CHIP,
+				   numa_node_id());
+	if (IS_ERR_VALUE(irq_base)) {
+		WARN(1, "Cannot allocate irq_descs @ IRQ%d, assuming pre-allocated\n",
+		     irq_start);
+		irq_base = irq_start;
+	}
 	nmk_chip->domain = irq_domain_add_legacy(np, NMK_GPIO_PER_CHIP,
-						NOMADIK_GPIO_TO_IRQ(pdata->first_gpio),
-						0, &nmk_gpio_irq_simple_ops, nmk_chip);
+				irq_base, 0,
+				&nmk_gpio_irq_simple_ops, nmk_chip);
 	if (!nmk_chip->domain) {
 		dev_err(&dev->dev, "failed to create irqdomain\n");
 		ret = -ENOSYS;
-- 
1.7.11.3