[PATCHv7 17/21] ARM: OMAP4: TWL: enable high speed mode for PMIC communication

[Tero Kristo]

On Wed, 2012-09-26 at 14:39 +0300, Peter Ujfalusi wrote:
> Hi Tero,
> 
> On 09/25/2012 07:33 PM, Tero Kristo wrote:
> > With the new parameters, I2C can now be put to high speed mode for
> > better performance.
> 
> We have twl6040 on the same bus. have you tried this with audio enabled?
> twl6040 is in standard mode (up to 100 kbps) after power up...

No, I don't have capability to try out audio. Can you give it a shot and
see what happens? Otherwise we probably just have to drop this patch out
for now.

-Tero

> 
> > 
> > Signed-off-by: Tero Kristo <t-kristo at ti.com>
> > ---
> >  arch/arm/mach-omap2/omap_twl.c |    1 +
> >  1 files changed, 1 insertions(+), 0 deletions(-)
> > 
> > diff --git a/arch/arm/mach-omap2/omap_twl.c b/arch/arm/mach-omap2/omap_twl.c
> > index 611cb63..7ff9667 100644
> > --- a/arch/arm/mach-omap2/omap_twl.c
> > +++ b/arch/arm/mach-omap2/omap_twl.c
> > @@ -218,6 +218,7 @@ static struct omap_voltdm_pmic omap4_core_pmic = {
> >  	.i2c_slave_addr		= OMAP4_SRI2C_SLAVE_ADDR,
> >  	.volt_reg_addr		= OMAP4_VDD_CORE_SR_VOLT_REG,
> >  	.cmd_reg_addr		= OMAP4_VDD_CORE_SR_CMD_REG,
> > +	.i2c_high_speed		= true,
> >  	.i2c_pad_load		= 3,
> >  	.vsel_to_uv		= twl6030_vsel_to_uv,
> >  	.uv_to_vsel		= twl6030_uv_to_vsel,
> > 
> 
>