[PATCH] serial: omap: fix the overrun case

[Shubhrajyoti D]

Overrun also causes an internal flag to be set, which disables further
reception. Before the next frame can
be received, the MPU must:
• Reset the RX FIFO.
• clear the internal flag.

In the uart mode a dummy read is needed. Add the same.

Signed-off-by: Shubhrajyoti D <shubhrajyoti at ti.com>
---
- functional testing on omap4sdp
- Verified idle and suspend path hits off on beagle.

 drivers/tty/serial/omap-serial.c |    7 +++++++
 1 files changed, 7 insertions(+), 0 deletions(-)

diff --git a/drivers/tty/serial/omap-serial.c b/drivers/tty/serial/omap-serial.c
index a0d4460..bc22a2b 100644
--- a/drivers/tty/serial/omap-serial.c
+++ b/drivers/tty/serial/omap-serial.c
@@ -334,6 +334,13 @@ static unsigned int check_modem_status(struct uart_omap_port *up)
 static void serial_omap_rlsi(struct uart_omap_port *up, unsigned int lsr)
 {
 	unsigned int flag;
+	unsigned char ch = 0;
+
+	if (!(lsr & UART_LSR_BRK_ERROR_BITS))
+		return;
+
+	if (likely(lsr & UART_LSR_DR))
+		ch = serial_in(up, UART_RX);
 
 	up->port.icount.rx++;
 	flag = TTY_NORMAL;
-- 
1.7.5.4