[PATCH] ARM: hw_breakpoint: Clear breakpoints before enabling monitor mode

[Stephen Boyd]

The reset value of the BCR, BVR, WCR, and WVR registers are all
UNKNOWN on ARMv7. Unfortunately, reset_ctrl_regs() clears these
registers *after* enabling monitor mode, not before, and so some
implementations may experience UNPREDICTABLE behavior if the
reset values of these registers are non-zero. Clear the
breakpoints before enabling monitor mode so that we don't
experience boot hangs/loops due to breakpoints being enabled
out of reset.

Signed-off-by: Stephen Boyd <sboyd at codeaurora.org>
---
 arch/arm/kernel/hw_breakpoint.c | 24 ++++++++++++++++++------
 1 file changed, 18 insertions(+), 6 deletions(-)

diff --git a/arch/arm/kernel/hw_breakpoint.c b/arch/arm/kernel/hw_breakpoint.c
index ba386bd..9eac571 100644
--- a/arch/arm/kernel/hw_breakpoint.c
+++ b/arch/arm/kernel/hw_breakpoint.c
@@ -216,6 +216,20 @@ static int get_num_brps(void)
 	return core_has_mismatch_brps() ? brps - 1 : brps;
 }
 
+/* Determine if halting mode is enabled */
+static int halting_mode_enabled(void)
+{
+	u32 dscr;
+
+	ARM_DBG_READ(c1, 0, dscr);
+
+	if (WARN_ONCE(dscr & ARM_DSCR_HDBGEN,
+		"halting debug mode enabled. Unable to access hardware resources.\n")) {
+		return -EPERM;
+	}
+	return 0;
+}
+
 /*
  * In order to access the breakpoint/watchpoint control registers,
  * we must be running in debug monitor mode. Unfortunately, we can
@@ -225,16 +239,13 @@ static int get_num_brps(void)
 static int enable_monitor_mode(void)
 {
 	u32 dscr;
-	int ret = 0;
+	int ret;
 
 	ARM_DBG_READ(c1, 0, dscr);
 
 	/* Ensure that halting mode is disabled. */
-	if (WARN_ONCE(dscr & ARM_DSCR_HDBGEN,
-		"halting debug mode enabled. Unable to access hardware resources.\n")) {
-		ret = -EPERM;
+	if ((ret = halting_mode_enabled()))
 		goto out;
-	}
 
 	/* If monitor mode is already enabled, just return. */
 	if (dscr & ARM_DSCR_MDBGEN)
@@ -935,7 +946,7 @@ static void reset_ctrl_regs(void *unused)
 	isb();
 
 reset_regs:
-	if (enable_monitor_mode())
+	if (halting_mode_enabled())
 		return;
 
 	/* We must also reset any reserved registers. */
@@ -949,6 +960,7 @@ reset_regs:
 		write_wb_reg(ARM_BASE_WCR + i, 0UL);
 		write_wb_reg(ARM_BASE_WVR + i, 0UL);
 	}
+	enable_monitor_mode();
 }
 
 static int __cpuinit dbg_reset_notify(struct notifier_block *self,
-- 
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
hosted by The Linux Foundation