[GIT PULL 2/4] mxs sparse-irq support

[Shawn Guo]

On Wed, Sep 12, 2012 at 10:56:47PM -0700, Olof Johansson wrote:
> On Tue, Sep 11, 2012 at 03:54:57PM +0800, Shawn Guo wrote:
> > The following changes since commit d9875690d9b89a866022ff49e3fcea892345ad92:
> > 
> >   Linux 3.6-rc2 (2012-08-16 14:51:24 -0700)
> > 
> > are available in the git repository at:
> > 
> >   git://git.linaro.org/people/shawnguo/linux-2.6.git tags/mxs-sparse-irq
> > 
> > for you to fetch changes up to 6608f13fabdb1f9ecbd502763ba33ca2646834c8:
> > 
> >   ARM: mxs: remove mach/irqs.h (2012-09-03 09:32:17 +0800)
> > 
> > ----------------------------------------------------------------
> > mxs-sparse-irq
> > 
> > The series adds irqdomain support for mach-mxs and then enables
> > sparse-irq.  It dependes on pull request mxs-dt-3.7.
> 
> Thanks, pulled in under next/soc2 due to the dt dependency.
> 
> However, for the future: if you're truly dependent on the dt branch to
> build/boot, you should use that as a base for this branch. Otherwise you
> can end up in a state with git bisect where you only have this branch
> applied but not the other one.
> 
Ok.  That's actually a little bit easier for me, since I only need to
send you the branch that I tested with.

I got an impression that we should try hard to base pull-requests on
-rc.  That said, we should only base one branch/pull-request on another
when there is a dependency at file content level.  The build/boot level
dependency can just be sorted out in arm-soc tree when the branch gets
built into for-next or sent to Linus.

-- 
Regards,
Shawn