[PATCH v3 0/8] i2c: at91: cleanup and dt support
ludovic.desroches at atmel.com
Wed Sep 12 07:12:23 EDT 2012
Le 09/12/2012 12:16 PM, Wolfram Sang a écrit :
> On Wed, Sep 12, 2012 at 10:03:59AM +0200, Nicolas Ferre wrote:
>> On 09/12/2012 08:42 AM, ludovic.desroches at atmel.com :
>>> From: Ludovic Desroches <ludovic.desroches at atmel.com>
>>> This set of patches is based on Nikolaus at91_i2c driver.
>>> - only put multi-drive lines in the if...else statement (suggested
>>> by Warner Losh)
>> Hi Wolfram,
>> As said by Ludovic, this series goes on top of Nikolaus' one.
>> My Acked-by is already set on this one, so I think that I have nothing
>> more to do ;-)
>> BTW, in case you need help to sort all this, do not hesitate to contact
>> us... we can setup a git tree for this...
> I think I am fine. Patches look good. I wondered a bit about first
> removing the old driver, then adding the new one with regard to
> bisectability. But as the old driver depends on BROKEN, I think this is
> OK to do.
> One thing I'd like to make, though. I'd like to squash the following
> patches into one:
> drivers/i2c/busses/i2c-at91.c: add new driver
> i2c: at91: use managed resources
> i2c: at91: add warning about transmission issues for some devices
> i2c: at91: use an id table for SoC dependent parameters
> It is especially the last patch I am mostly interested in. The id_table
> approach is what I like, while the original id_entry mechanism looks
> fishy. I'd was good for reviewing to have the patches split like this;
> yet for hitting mainline, I'd prefer to have the driver proper on first
> occasion. I already did the squashing in a test-branch and the result
> looks good to me.
> Nikolaus, Ludovic: Are you fine with this?
No problem on my side.
More information about the linux-arm-kernel