[PATCH 1/1] ARM: dts: OMAP3: Add gpio-twl4030 properties for Overo

[Benoit Cousson]

On 09/10/2012 03:33 PM, Florian Vaussard wrote:
>>> Support the blue LED connected to the LEDB pin of the TWL4030
>>> on the Gumstix Overo.
>>>
>>> Signed-off-by: Florian Vaussard <florian.vaussard at epfl.ch>
>>> ---
>>>   arch/arm/boot/dts/omap3-overo.dtsi |   15 +++++++++++++++
>>>   1 files changed, 15 insertions(+), 0 deletions(-)
>>>
>>> diff --git a/arch/arm/boot/dts/omap3-overo.dtsi
>>> b/arch/arm/boot/dts/omap3-overo.dtsi
>>> index d6cc5e2..89808ce 100644
>>> --- a/arch/arm/boot/dts/omap3-overo.dtsi
>>> +++ b/arch/arm/boot/dts/omap3-overo.dtsi
>>> @@ -13,6 +13,17 @@
>>>
>>>   /include/ "omap3.dtsi"
>>>
>>> +/ {
>>
>> BTW, I'm just wondering. Cannot we use overo without tobi?
>>
>> In that case, the model and compatible should probably be used as well:
>>
>>     model = "TI OMAP3 Gumstix Overo";
>>     compatible = "ti,omap3-overo", "ti,omap3";
> 
> No, it cannot. The Overo needs to be plugged into an expansion board, at
> least to get the power. Hence the absence of model and compatible in
> omap3-overo.dtsi.

OK, cool. I was wondering because we already have a board-overo.c in the
kernel, and there is no mention of tobi.

OK, I'm adding that patch on top of the other then.

Regards,
Benoit