[PATCH] perf: Use pre-empt safe cpu_get/put insted of smp_processor_id

Roger Quadros rogerq at ti.com
Fri Sep 7 02:55:24 EDT 2012


Hi Jean,

My bad, I didn't follow up with this. My guess is that it has not been
picked up. Tony, Kevin?

regards,
-roger

On 09/06/2012 09:59 PM, Jean Pihet wrote:
> Fixed Paul's email address
> 
> On Thu, Sep 6, 2012 at 8:56 PM, Jean Pihet <jean.pihet at newoldbits.com> wrote:
>> Hi Roger,
>>
>> On Fri, Aug 10, 2012 at 4:05 PM, Roger Quadros <rogerq at ti.com> wrote:
>>> gets rid of below messages with CONFIG_DEBUG_PREEMPT enabled
>>>
>>> [   28.832916] debug_smp_processor_id: 18 callbacks suppressed
>>> [   28.832946] BUG: using smp_processor_id() in preemptible [00000000] code: modprobe/1763
>>> [   28.841491] caller is pwrdm_set_next_pwrst+0x54/0x120
>>>
>>> Signed-off-by: Roger Quadros <rogerq at ti.com>
>>
>> What his the status of the patch? Has it been reviewed and taken in an
>> integration tree? I cannot find anything about it in l-o and
>> linux-next.
>>
>> I have some changes on-going in the OMAP PM code and I would like to
>> know if $SUBJECT is applicable.
>>
>> Regards,
>> Jean
>>
>>> ---
>>>  arch/arm/mach-omap2/clock.c       |    9 ++++++---
>>>  arch/arm/mach-omap2/pm34xx.c      |   12 ++++++++----
>>>  arch/arm/mach-omap2/powerdomain.c |    6 ++++--
>>>  3 files changed, 18 insertions(+), 9 deletions(-)
>>>
>>> diff --git a/arch/arm/mach-omap2/clock.c b/arch/arm/mach-omap2/clock.c
>>> index ea3f565..06747b6 100644
>>> --- a/arch/arm/mach-omap2/clock.c
>>> +++ b/arch/arm/mach-omap2/clock.c
>>> @@ -285,7 +285,8 @@ void omap2_clk_disable(struct clk *clk)
>>>         pr_debug("clock: %s: disabling in hardware\n", clk->name);
>>>
>>>         if (clk->ops && clk->ops->disable) {
>>> -               trace_clock_disable(clk->name, 0, smp_processor_id());
>>> +               trace_clock_disable(clk->name, 0, get_cpu());
>>> +               put_cpu();
>>>                 clk->ops->disable(clk);
>>>         }
>>>
>>> @@ -339,7 +340,8 @@ int omap2_clk_enable(struct clk *clk)
>>>         }
>>>
>>>         if (clk->ops && clk->ops->enable) {
>>> -               trace_clock_enable(clk->name, 1, smp_processor_id());
>>> +               trace_clock_enable(clk->name, 1, get_cpu());
>>> +               put_cpu();
>>>                 ret = clk->ops->enable(clk);
>>>                 if (ret) {
>>>                         WARN(1, "clock: %s: could not enable: %d\n",
>>> @@ -380,7 +382,8 @@ int omap2_clk_set_rate(struct clk *clk, unsigned long rate)
>>>
>>>         /* dpll_ck, core_ck, virt_prcm_set; plus all clksel clocks */
>>>         if (clk->set_rate) {
>>> -               trace_clock_set_rate(clk->name, rate, smp_processor_id());
>>> +               trace_clock_set_rate(clk->name, rate, get_cpu());
>>> +               put_cpu();
>>>                 ret = clk->set_rate(clk, rate);
>>>         }
>>>
>>> diff --git a/arch/arm/mach-omap2/pm34xx.c b/arch/arm/mach-omap2/pm34xx.c
>>> index e4fc88c..81fec2e 100644
>>> --- a/arch/arm/mach-omap2/pm34xx.c
>>> +++ b/arch/arm/mach-omap2/pm34xx.c
>>> @@ -357,18 +357,22 @@ void omap_sram_idle(void)
>>>
>>>  static void omap3_pm_idle(void)
>>>  {
>>> +       unsigned cpu;
>>> +
>>>         local_fiq_disable();
>>>
>>>         if (omap_irq_pending())
>>>                 goto out;
>>>
>>> -       trace_power_start(POWER_CSTATE, 1, smp_processor_id());
>>> -       trace_cpu_idle(1, smp_processor_id());
>>> +       cpu = get_cpu();
>>> +       trace_power_start(POWER_CSTATE, 1, cpu);
>>> +       trace_cpu_idle(1, cpu);
>>>
>>>         omap_sram_idle();
>>>
>>> -       trace_power_end(smp_processor_id());
>>> -       trace_cpu_idle(PWR_EVENT_EXIT, smp_processor_id());
>>> +       trace_power_end(cpu);
>>> +       trace_cpu_idle(PWR_EVENT_EXIT, cpu);
>>> +       put_cpu();
>>>
>>>  out:
>>>         local_fiq_enable();
>>> diff --git a/arch/arm/mach-omap2/powerdomain.c b/arch/arm/mach-omap2/powerdomain.c
>>> index 69b36e1..138bf86 100644
>>> --- a/arch/arm/mach-omap2/powerdomain.c
>>> +++ b/arch/arm/mach-omap2/powerdomain.c
>>> @@ -169,7 +169,8 @@ static int _pwrdm_state_switch(struct powerdomain *pwrdm, int flag)
>>>                                        ((state & OMAP_POWERSTATE_MASK) << 8) |
>>>                                        ((prev & OMAP_POWERSTATE_MASK) << 0));
>>>                         trace_power_domain_target(pwrdm->name, trace_state,
>>> -                                                 smp_processor_id());
>>> +                                                 get_cpu());
>>> +                       put_cpu();
>>>                 }
>>>                 break;
>>>         default:
>>> @@ -491,7 +492,8 @@ int pwrdm_set_next_pwrst(struct powerdomain *pwrdm, u8 pwrst)
>>>         if (arch_pwrdm && arch_pwrdm->pwrdm_set_next_pwrst) {
>>>                 /* Trace the pwrdm desired target state */
>>>                 trace_power_domain_target(pwrdm->name, pwrst,
>>> -                                         smp_processor_id());
>>> +                                         get_cpu());
>>> +               put_cpu();
>>>                 /* Program the pwrdm desired target state */
>>>                 ret = arch_pwrdm->pwrdm_set_next_pwrst(pwrdm, pwrst);
>>>         }
>>> --
>>> 1.7.4.1
>>>




More information about the linux-arm-kernel mailing list