[PATCH v6 2/3] arm/dts: AM33XX: Configure pinmuxs for user leds control on Bone

AnilKumar, Chimata anilkumar at ti.com
Thu Sep 6 23:23:16 EDT 2012


Tony,

On Fri, Sep 07, 2012 at 02:28:12, Tony Lindgren wrote:
> * AnilKumar Ch <anilkumar at ti.com> [120905 04:42]:
> > Adds GPIO pinctrl nodes to am3358_pinmux master node to control
> > user leds (USR0, USR1, USR2 and USR3) present on BeagleBone.
> > 
> > [koen at dominion.thruhere.net: led0, led1 suggested by koen]
> > Signed-off-by: AnilKumar Ch <anilkumar at ti.com>
> > ---
> >  arch/arm/boot/dts/am335x-bone.dts |   43 +++++++++++++++++++++++++++++++++++++
> >  1 file changed, 43 insertions(+)
> > 
> > diff --git a/arch/arm/boot/dts/am335x-bone.dts b/arch/arm/boot/dts/am335x-bone.dts
> > index c634f87..822efe6 100644
> > --- a/arch/arm/boot/dts/am335x-bone.dts
> > +++ b/arch/arm/boot/dts/am335x-bone.dts
> > @@ -18,11 +18,54 @@
> >  		reg = <0x80000000 0x10000000>; /* 256 MB */
> >  	};
> >  
> > +	am3358_pinmux: pinmux at 44e10800 {
> > +		userled_pins: pinmux_userled_pins {
> > +			pinctrl-single,pins = <
> > +				0x54 0x7	/* gpmc_a5.gpio1_21, OUTPUT | MODE7 */
> > +				0x58 0x17	/* gpmc_a6.gpio1_22, OUTPUT_PULLUP | MODE7 */
> > +				0x5c 0x7	/* gpmc_a7.gpio1_23, OUTPUT | MODE7 */
> > +				0x60 0x17	/* gpmc_a8.gpio1_24, OUTPUT_PULLUP | MODE7 */
> > +			>;
> > +		};
> > +	};
> > +
> 
> Just checking.. am3358_pinmux should be am33xx_pinmux in this patch
> too as discussed.
> 

Yes, this is also changed in v7.

Thanks
AnilKumar



More information about the linux-arm-kernel mailing list