[PATCH 4/4 v5] ARM: ks8695: convert to generic time and clocksource
Linus Walleij
linus.walleij at linaro.org
Wed Sep 5 01:23:15 EDT 2012
Old platforms using ancient gettimeoffset() and other arcane
APIs are standing in the way of cleaning up the ARM kernel.
The gettimeoffset() was also broken: it would try to read out
the timer counter value, while this would not work (the
counter statically returns the initially programmed value)
so the implementation would anyway fall back to a homebrew
version of jiffie calculation.
This is an attempt at blind-coding a generic time and clocksource
driver for the platform by way of a datasheet and looking at the
old code.
Signed-off-by: Linus Walleij <linus.walleij at linaro.org>
---
ChangeLog v4->v5:
- Don't unconditionally disable timer 1 in the set_mode()
function, this reportedly hangs the platform in loop
calibration.
ChangeLog v3->v4:
- Skip trying to provide an MMIO clocksource, there is no
clocksource to be found on this system, so set up a clockevent
and let the timekeeping core fall back to jiffies.
ChangeLog v2->v3:
- Correct the MMIO timer read function: this timer counts DOWN
not up - since clocksources shall move forward in time, the
ever decreasing clocksource was likely ignored.
ChangeLog v1->v2:
- Corrected the mask when setting clockevents from & TMCON_T1EN
to & ~TMCON_T1EN so it doesn't shut down the clock source.
---
arch/arm/Kconfig | 3 +-
arch/arm/mach-ks8695/time.c | 105 ++++++++++++++++++++++++++++----------------
2 files changed, 69 insertions(+), 39 deletions(-)
diff --git a/arch/arm/Kconfig b/arch/arm/Kconfig
index 6d6e18f..e9ce038 100644
--- a/arch/arm/Kconfig
+++ b/arch/arm/Kconfig
@@ -652,8 +652,9 @@ config ARCH_KS8695
bool "Micrel/Kendin KS8695"
select CPU_ARM922T
select ARCH_REQUIRE_GPIOLIB
- select ARCH_USES_GETTIMEOFFSET
select NEED_MACH_MEMORY_H
+ select CLKSRC_MMIO
+ select GENERIC_CLOCKEVENTS
help
Support for Micrel/Kendin KS8695 "Centaur" (ARM922T) based
System-on-Chip devices.
diff --git a/arch/arm/mach-ks8695/time.c b/arch/arm/mach-ks8695/time.c
index 6974c23..46c84bc 100644
--- a/arch/arm/mach-ks8695/time.c
+++ b/arch/arm/mach-ks8695/time.c
@@ -25,6 +25,7 @@
#include <linux/kernel.h>
#include <linux/sched.h>
#include <linux/io.h>
+#include <linux/clockchips.h>
#include <asm/mach/time.h>
#include <asm/system_misc.h>
@@ -53,44 +54,69 @@
/* Timer0 Timeout Counter Register */
#define T0TC_WATCHDOG (0xff) /* Enable watchdog mode */
-/*
- * Returns number of ms since last clock interrupt. Note that interrupts
- * will have been disabled by do_gettimeoffset()
- */
-static unsigned long ks8695_gettimeoffset (void)
+static void ks8695_set_mode(enum clock_event_mode mode,
+ struct clock_event_device *evt)
{
- unsigned long elapsed, tick2, intpending;
+ u32 tmcon;
- /*
- * Get the current number of ticks. Note that there is a race
- * condition between us reading the timer and checking for an
- * interrupt. We solve this by ensuring that the counter has not
- * reloaded between our two reads.
- */
- elapsed = readl_relaxed(KS8695_TMR_VA + KS8695_T1TC) + readl_relaxed(KS8695_TMR_VA + KS8695_T1PD);
- do {
- tick2 = elapsed;
- intpending = readl_relaxed(KS8695_IRQ_VA + KS8695_INTST) & (1 << KS8695_IRQ_TIMER1);
- elapsed = readl_relaxed(KS8695_TMR_VA + KS8695_T1TC) + readl_relaxed(KS8695_TMR_VA + KS8695_T1PD);
- } while (elapsed > tick2);
-
- /* Convert to number of ticks expired (not remaining) */
- elapsed = (CLOCK_TICK_RATE / HZ) - elapsed;
-
- /* Is interrupt pending? If so, then timer has been reloaded already. */
- if (intpending)
- elapsed += (CLOCK_TICK_RATE / HZ);
-
- /* Convert ticks to usecs */
- return (unsigned long)(elapsed * (tick_nsec / 1000)) / LATCH;
+ if (mode == CLOCK_EVT_FEAT_PERIODIC) {
+ u32 rate = DIV_ROUND_CLOSEST(KS8695_CLOCK_RATE, HZ);
+ u32 half = DIV_ROUND_CLOSEST(rate, 2);
+
+ /* Disable timer 1 */
+ tmcon = readl_relaxed(KS8695_TMR_VA + KS8695_TMCON);
+ tmcon &= ~TMCON_T1EN;
+ writel_relaxed(tmcon, KS8695_TMR_VA + KS8695_TMCON);
+
+ /* Both registers need to count down */
+ writel_relaxed(half, KS8695_TMR_VA + KS8695_T1TC);
+ writel_relaxed(half, KS8695_TMR_VA + KS8695_T1PD);
+
+ /* Re-enable timer1 */
+ tmcon |= TMCON_T1EN;
+ writel_relaxed(tmcon, KS8695_TMR_VA + KS8695_TMCON);
+ }
+}
+
+static int ks8695_set_next_event(unsigned long cycles,
+ struct clock_event_device *evt)
+
+{
+ u32 half = DIV_ROUND_CLOSEST(cycles, 2);
+ u32 tmcon;
+
+ /* Disable timer 1 */
+ tmcon = readl_relaxed(KS8695_TMR_VA + KS8695_TMCON);
+ tmcon &= ~TMCON_T1EN;
+ writel_relaxed(tmcon, KS8695_TMR_VA + KS8695_TMCON);
+
+ /* Both registers need to count down */
+ writel_relaxed(half, KS8695_TMR_VA + KS8695_T1TC);
+ writel_relaxed(half, KS8695_TMR_VA + KS8695_T1PD);
+
+ /* Re-enable timer1 */
+ tmcon |= TMCON_T1EN;
+ writel_relaxed(tmcon, KS8695_TMR_VA + KS8695_TMCON);
+
+ return 0;
}
+static struct clock_event_device clockevent_ks8695 = {
+ .name = "ks8695_t1tc",
+ .rating = 300, /* Reasonably fast and accurate clock event */
+ .features = CLOCK_EVT_FEAT_ONESHOT | CLOCK_EVT_FEAT_PERIODIC,
+ .set_next_event = ks8695_set_next_event,
+ .set_mode = ks8695_set_mode,
+};
+
/*
* IRQ handler for the timer.
*/
static irqreturn_t ks8695_timer_interrupt(int irq, void *dev_id)
{
- timer_tick();
+ struct clock_event_device *evt = &clockevent_ks8695;
+
+ evt->event_handler(evt);
return IRQ_HANDLED;
}
@@ -102,18 +128,22 @@ static struct irqaction ks8695_timer_irq = {
static void ks8695_timer_setup(void)
{
- unsigned long tmout = CLOCK_TICK_RATE / HZ;
unsigned long tmcon;
- /* disable timer1 */
+ /* Disable timer 0 and 1 */
tmcon = readl_relaxed(KS8695_TMR_VA + KS8695_TMCON);
- writel_relaxed(tmcon & ~TMCON_T1EN, KS8695_TMR_VA + KS8695_TMCON);
-
- writel_relaxed(tmout / 2, KS8695_TMR_VA + KS8695_T1TC);
- writel_relaxed(tmout / 2, KS8695_TMR_VA + KS8695_T1PD);
+ tmcon &= ~TMCON_T0EN;
+ tmcon &= ~TMCON_T1EN;
+ writel_relaxed(tmcon, KS8695_TMR_VA + KS8695_TMCON);
- /* re-enable timer1 */
- writel_relaxed(tmcon | TMCON_T1EN, KS8695_TMR_VA + KS8695_TMCON);
+ /*
+ * Use timer 1 to fire IRQs on the timeline, minimum 2 cycles
+ * (one on each counter) maximum 2*2^32, but the API will only
+ * accept up to a 32bit full word (0xFFFFFFFFU).
+ */
+ clockevents_config_and_register(&clockevent_ks8695,
+ KS8695_CLOCK_RATE, 2,
+ 0xFFFFFFFFU);
}
static void __init ks8695_timer_init (void)
@@ -126,7 +156,6 @@ static void __init ks8695_timer_init (void)
struct sys_timer ks8695_timer = {
.init = ks8695_timer_init,
- .offset = ks8695_gettimeoffset,
};
void ks8695_restart(char mode, const char *cmd)
--
1.7.11.4
More information about the linux-arm-kernel
mailing list