MX28 & finding out boot mode

[Marek Vasut]

Dear Wolfram Sang,

> On Thu, Aug 30, 2012 at 09:40:05AM +0000, Chen Peter-B29397 wrote:
> > > Some customers want this to handle the recovery case differently than
> > > the standard case.
> > 
> > If you can't find method at datasheet (like reading some registers), a
> > workaround
> 
> I hoped there was one bit in the persistent registers where the ROM
> code stores such stuff. Sadly, those are usually not documented, so I
> asked.
> 
> > is according to usb register, usually, usbcmd.rs (pull-up DP) stands for
> > usb is using or not.
> 
> I think this is too much of a workaround for me :)

I cycled the board a few times and checked the ICOLL setup, but I gave up since 
I don't care enough.

btw. did you cc me on gmail intentionally ? ;-)

> Thanks anyway!

Best regards,
Marek Vasut