[PATCH 1/4] net: fec: move fec_enet_private to header file
Frank Li
Frank.Li at freescale.com
Wed Oct 31 00:24:49 EDT 2012
A new file fec_ptp.c will use fec_enet_private to support 1588 PTP
move such structure to common header file fec.h
Signed-off-by: Frank Li <Frank.Li at freescale.com>
---
drivers/net/ethernet/freescale/fec.c | 73 ------------------------------
drivers/net/ethernet/freescale/fec.h | 81 ++++++++++++++++++++++++++++++++++
2 files changed, 81 insertions(+), 73 deletions(-)
diff --git a/drivers/net/ethernet/freescale/fec.c b/drivers/net/ethernet/freescale/fec.c
index fffd205..d0e1b33 100644
--- a/drivers/net/ethernet/freescale/fec.c
+++ b/drivers/net/ethernet/freescale/fec.c
@@ -140,21 +140,6 @@ MODULE_PARM_DESC(macaddr, "FEC Ethernet MAC address");
#endif
#endif /* CONFIG_M5272 */
-/* The number of Tx and Rx buffers. These are allocated from the page
- * pool. The code may assume these are power of two, so it it best
- * to keep them that size.
- * We don't need to allocate pages for the transmitter. We just use
- * the skbuffer directly.
- */
-#define FEC_ENET_RX_PAGES 8
-#define FEC_ENET_RX_FRSIZE 2048
-#define FEC_ENET_RX_FRPPG (PAGE_SIZE / FEC_ENET_RX_FRSIZE)
-#define RX_RING_SIZE (FEC_ENET_RX_FRPPG * FEC_ENET_RX_PAGES)
-#define FEC_ENET_TX_FRSIZE 2048
-#define FEC_ENET_TX_FRPPG (PAGE_SIZE / FEC_ENET_TX_FRSIZE)
-#define TX_RING_SIZE 16 /* Must be power of two */
-#define TX_RING_MOD_MASK 15 /* for this to work */
-
#if (((RX_RING_SIZE + TX_RING_SIZE) * 8) > PAGE_SIZE)
#error "FEC: descriptor ring size constants too large"
#endif
@@ -179,9 +164,6 @@ MODULE_PARM_DESC(macaddr, "FEC Ethernet MAC address");
#define PKT_MINBUF_SIZE 64
#define PKT_MAXBLR_SIZE 1520
-/* This device has up to three irqs on some platforms */
-#define FEC_IRQ_NUM 3
-
/*
* The 5270/5271/5280/5282/532x RX control register also contains maximum frame
* size bits. Other FEC hardware does not, so we need to take that into
@@ -194,61 +176,6 @@ MODULE_PARM_DESC(macaddr, "FEC Ethernet MAC address");
#define OPT_FRAME_SIZE 0
#endif
-/* The FEC buffer descriptors track the ring buffers. The rx_bd_base and
- * tx_bd_base always point to the base of the buffer descriptors. The
- * cur_rx and cur_tx point to the currently available buffer.
- * The dirty_tx tracks the current buffer that is being sent by the
- * controller. The cur_tx and dirty_tx are equal under both completely
- * empty and completely full conditions. The empty/ready indicator in
- * the buffer descriptor determines the actual condition.
- */
-struct fec_enet_private {
- /* Hardware registers of the FEC device */
- void __iomem *hwp;
-
- struct net_device *netdev;
-
- struct clk *clk_ipg;
- struct clk *clk_ahb;
-
- /* The saved address of a sent-in-place packet/buffer, for skfree(). */
- unsigned char *tx_bounce[TX_RING_SIZE];
- struct sk_buff* tx_skbuff[TX_RING_SIZE];
- struct sk_buff* rx_skbuff[RX_RING_SIZE];
- ushort skb_cur;
- ushort skb_dirty;
-
- /* CPM dual port RAM relative addresses */
- dma_addr_t bd_dma;
- /* Address of Rx and Tx buffers */
- struct bufdesc *rx_bd_base;
- struct bufdesc *tx_bd_base;
- /* The next free ring entry */
- struct bufdesc *cur_rx, *cur_tx;
- /* The ring entries to be free()ed */
- struct bufdesc *dirty_tx;
-
- uint tx_full;
- /* hold while accessing the HW like ringbuffer for tx/rx but not MAC */
- spinlock_t hw_lock;
-
- struct platform_device *pdev;
-
- int opened;
- int dev_id;
-
- /* Phylib and MDIO interface */
- struct mii_bus *mii_bus;
- struct phy_device *phy_dev;
- int mii_timeout;
- uint phy_speed;
- phy_interface_t phy_interface;
- int link;
- int full_duplex;
- struct completion mdio_done;
- int irq[FEC_IRQ_NUM];
-};
-
/* FEC MII MMFR bits definition */
#define FEC_MMFR_ST (1 << 30)
#define FEC_MMFR_OP_READ (2 << 28)
diff --git a/drivers/net/ethernet/freescale/fec.h b/drivers/net/ethernet/freescale/fec.h
index 8408c62..e803812 100644
--- a/drivers/net/ethernet/freescale/fec.h
+++ b/drivers/net/ethernet/freescale/fec.h
@@ -147,6 +147,87 @@ struct bufdesc {
#define BD_ENET_TX_CSL ((ushort)0x0001)
#define BD_ENET_TX_STATS ((ushort)0x03ff) /* All status bits */
+/*enhanced buffer desciptor control/status used by Ethernet transmit*/
+#define BD_ENET_TX_INT 0x40000000
+#define BD_ENET_TX_TS 0x20000000
+
+
+/* This device has up to three irqs on some platforms */
+#define FEC_IRQ_NUM 3
+
+/* The number of Tx and Rx buffers. These are allocated from the page
+ * pool. The code may assume these are power of two, so it it best
+ * to keep them that size.
+ * We don't need to allocate pages for the transmitter. We just use
+ * the skbuffer directly.
+ */
+
+#define FEC_ENET_RX_PAGES 8
+#define FEC_ENET_RX_FRSIZE 2048
+#define FEC_ENET_RX_FRPPG (PAGE_SIZE / FEC_ENET_RX_FRSIZE)
+#define RX_RING_SIZE (FEC_ENET_RX_FRPPG * FEC_ENET_RX_PAGES)
+#define FEC_ENET_TX_FRSIZE 2048
+#define FEC_ENET_TX_FRPPG (PAGE_SIZE / FEC_ENET_TX_FRSIZE)
+#define TX_RING_SIZE 16 /* Must be power of two */
+#define TX_RING_MOD_MASK 15 /* for this to work */
+
+#define BD_ENET_RX_INT 0x00800000
+#define BD_ENET_RX_PTP ((ushort)0x0400)
+
+/* The FEC buffer descriptors track the ring buffers. The rx_bd_base and
+ * tx_bd_base always point to the base of the buffer descriptors. The
+ * cur_rx and cur_tx point to the currently available buffer.
+ * The dirty_tx tracks the current buffer that is being sent by the
+ * controller. The cur_tx and dirty_tx are equal under both completely
+ * empty and completely full conditions. The empty/ready indicator in
+ * the buffer descriptor determines the actual condition.
+ */
+struct fec_enet_private {
+ /* Hardware registers of the FEC device */
+ void __iomem *hwp;
+
+ struct net_device *netdev;
+
+ struct clk *clk_ipg;
+ struct clk *clk_ahb;
+
+ /* The saved address of a sent-in-place packet/buffer, for skfree(). */
+ unsigned char *tx_bounce[TX_RING_SIZE];
+ struct sk_buff *tx_skbuff[TX_RING_SIZE];
+ struct sk_buff *rx_skbuff[RX_RING_SIZE];
+ ushort skb_cur;
+ ushort skb_dirty;
+
+ /* CPM dual port RAM relative addresses */
+ dma_addr_t bd_dma;
+ /* Address of Rx and Tx buffers */
+ struct bufdesc *rx_bd_base;
+ struct bufdesc *tx_bd_base;
+ /* The next free ring entry */
+ struct bufdesc *cur_rx, *cur_tx;
+ /* The ring entries to be free()ed */
+ struct bufdesc *dirty_tx;
+
+ uint tx_full;
+ /* hold while accessing the HW like ringbuffer for tx/rx but not MAC */
+ spinlock_t hw_lock;
+
+ struct platform_device *pdev;
+
+ int opened;
+ int dev_id;
+
+ /* Phylib and MDIO interface */
+ struct mii_bus *mii_bus;
+ struct phy_device *phy_dev;
+ int mii_timeout;
+ uint phy_speed;
+ phy_interface_t phy_interface;
+ int link;
+ int full_duplex;
+ struct completion mdio_done;
+ int irq[FEC_IRQ_NUM];
+};
/****************************************************************************/
#endif /* FEC_H */
--
1.7.1
More information about the linux-arm-kernel
mailing list