OMAP baseline test results for v3.7-rc3

[Tony Lindgren]

* Felipe Balbi <balbi at ti.com> [121030 10:34]:
> Hi,
> 
> On Tue, Oct 30, 2012 at 09:27:28AM -0700, Tony Lindgren wrote:
> > * Vaibhav Hiremath <hvaibhav at ti.com> [121030 07:50]:
> > > > 
> > > > MMC is dependent on EDMA-DMA conversion patches from Matt, which he has 
> > > > already submitted to the list recently. So MMC support will come along with
> > > > EDMA support. DMA-EDMA patches are targeted for v3.8, lets see how it goes.
> > 
> > This is a bogus dependency, the MMC driver needs to also work
> > without DMA.
> 
> heh, too bad driver errors out when it doesn't find DMA channels :-)

It should just print a warning instead and continue.
 
> 1869         host->rx_chan = dma_request_channel(mask, omap_dma_filter_fn, &rx_req);
> 1870         if (!host->rx_chan) {
> 1871                 dev_err(mmc_dev(host->mmc), "unable to obtain RX DMA engine channel %u\n", rx_req);
> 1872                 ret = -ENXIO;
> 1873                 goto err_irq;
> 1874         }
> 1875 
> 1876         host->tx_chan = dma_request_channel(mask, omap_dma_filter_fn, &tx_req);
> 1877         if (!host->tx_chan) {
> 1878                 dev_err(mmc_dev(host->mmc), "unable to obtain TX DMA engine channel %u\n", tx_req);
> 1879                 ret = -ENXIO;
> 1880                 goto err_irq;
> 1881         }
> 
> in fact, if DMAENGINE isn't enabled, this won't even compile due to
> omap_dma_filter_fn() right ?

It should, CONFIG_DMADEVICES is optional. If it does not compile,
then there's a bug somewhere.

Regards,

Tony