[PATCH v2 4/7] i2c: omap: in case of VERSION_2 read IRQSTATUS_RAW but write to IRQSTATUS

[Santosh Shilimkar]

On Thursday 25 October 2012 05:55 PM, Felipe Balbi wrote:
> on OMAP4+ we want to read IRQSTATUS_RAW register,
> instead of IRQSTATUS. The reason being that IRQSTATUS
> will only contain the bits which were enabled on
> IRQENABLE_SET and that will break when we need to
> poll for a certain bit which wasn't enabled as an
> IRQ source.
>
> One such case is after we finish converting to
> deferred stop bit, we will have to poll for ARDY
> bit before returning control for the client driver
> in order to prevent us from trying to start a
> transfer on a bus which is already busy.
>
> Note, however, that omap-i2c.c needs a big rework
> on register definition and register access. Such
> work will be done in a separate series of patches.
>
> Cc: Benoit Cousson <b-cousson at ti.com>
> Signed-off-by: Felipe Balbi <balbi at ti.com>
> ---
>   drivers/i2c/busses/i2c-omap.c | 12 +++++++++++-
>   1 file changed, 11 insertions(+), 1 deletion(-)
>
> diff --git a/drivers/i2c/busses/i2c-omap.c b/drivers/i2c/busses/i2c-omap.c
> index b004126..20f9ad6 100644
> --- a/drivers/i2c/busses/i2c-omap.c
> +++ b/drivers/i2c/busses/i2c-omap.c
> @@ -271,8 +271,18 @@ static inline void omap_i2c_write_reg(struct omap_i2c_dev *i2c_dev,
>
>   static inline u16 omap_i2c_read_reg(struct omap_i2c_dev *i2c_dev, int reg)
>   {
> -	return __raw_readw(i2c_dev->base +
> +	/* if we are OMAP_I2C_IP_VERSION_2, we need to read from
> +	 * IRQSTATUS_RAW, but write to IRQSTATUS
> +	 */
> +	if ((i2c_dev->dtrev == OMAP_I2C_IP_VERSION_2) &&
> +			(reg == OMAP_I2C_STAT_REG)) {
Doing this check on every I2C register read seems to
expensive to me. Can you not sort this in init with some offset
which can be 0 or non zero ?  Sorry in case this is already dicussed.

regards
santosh