[PATCH] ARM: dt: tegra: ventana: define pinmux for ddc

[Mark Zhang]

On 10/19/2012 11:48 PM, Stephen Warren wrote:
> On 10/18/2012 11:58 PM, Mark Zhang wrote:
>> Define pinmux for DDC. The DDC pinmux in Ventana is 2 pins in I2C2.
>
>> +++ b/arch/arm/boot/dts/tegra20-ventana.dts
>
>> -			ddc {
>> -				nvidia,pins = "ddc", "owc", "spdi", "spdo",
>> -					"uac";
>> -				nvidia,function = "rsvd2";
>> -			};
>
> So that removes the entries for 5 pin groups, yet below, entries are
> only added for the ddc and pta pingroups, so the other 4 pin groups
> become unconfigured.
>

Right. So I think it should be changed to:

		owc {
			nvidia,pins = "owc", "spdi", "spdo", "uac";
			nvidia,function = "rsvd2";
		};

Is this right?

>> +
>> +		state_i2cmux_ddc: pinmux_i2cmux_ddc {
>> +			ddc {
>> +				nvidia,pins = "ddc";
>> +				nvidia,function = "i2c2";
>> +			};
>> +			pta {
>> +				nvidia,pins = "pta";
>> +				nvidia,function = "rsvd4";
>> +			};
>
> Does this actually work? The pta pingroup is configured by the "hog"
> pinctrl state of the pinctrl node itself, so this state should fail to
> be applied since it attempts to touch the same pingroup.
>

I know little about kernel pinctrl subsystem. After reading some docs 
and codes, I think what you mean is, in Ventana's pinmux configuration, 
pta pingroup has been defined as "hdmi" function and this can't be 
changed(non-dynamic pinmuxing).
So I want to know why we have defined pta pingroup as hdmi function?
Can we remove this definition to make the i2cmux above working?

>> +	i2cmux {
> ...
>> +		i2c at 1 {
>> +			reg = <1>;
>> +			#address-cells = <1>;
>> +			#size-cells = <0>;
>> +
>> +			smart-battery at b {
>> +				compatible = "ti,bq24617", "smart-battery-1.1";
>> +				reg = <0xb>;
>> +				ti,i2c-retry-count = <2>;
>> +				ti,poll-retry-count = <10>;
>> +			};
>
> That wasn't there before. Does that device actually exist on Ventana?
> Adding it should be a separate patch if so, since this one is just about
> introducing the I2C mux, not adding an SBS device. Was this all just
> cut/paste from Seaboard without validation?
>

Yes, I didn't validate this. Actually, I don't know how to validate. I 
have no idea about SBS device. But I have checked the schematic of 
Ventana and it has this "bq24617" battery charge controller(for 
seaboard, it's bq20z75).
So I agree with you not to include this part in the patch.